SCA PLU 570908 Dynamic Guideline Reverse Camera User Manual
Product Overview
Thank you for purchasing the SCA-RC2 Dynamic guideline reversing camera. The Dynamic guidelines show the path
of intended motion of the vehicle while reversing. This product is designed for easy DIY installation but does require some specific tools.
Package Components
Wiring Install Diagram
The video signal is transferred from the camera to a monitor/display via an RCA cable that will need to be run
through the boot, through the passenger compartment to the monitor/display wired loom, run under the dash. Check the priority input on the monitor/display.
Wiring Diagram
Installation
Choose aposition that does not impede the access/operation of the boot release or tailgate latch.
- Use a suitable splicing/crimp connector (scotch lock type) or strip connector. The camera power harness has two wires to connect (positive (+) to reverse lamp and (-) to chassis or negative of lamp.
- After you have insulated the join you can connect the camera power harness to the camera.
- This is where the monitor/display loom will be located. To do this you may need to remove the rear seat and or door scuff plates to run the wire along the side of the vehicle.
- Refer to your monitor/display manual on how to connect to the RCA and energized wire from the video adapter cable.
- Connect the RCA cable to the RCA socket from the monitors/display loom.
Product Specifications
| Sensor | CMOS |
| Lens view angle | 120 degree wide viewing angle |
| Resolution | 480 (TV Lines) |
| Effective pixels | 580*492 |
| TV system | PAL |
| Power supply | DC12V |
| Waterproof | IP67 |
| Power consumption | Less than 100mA |
| Chipset | 7740 chip |
| Min illumination | 0.1Lux |
| Dimensions | W38 x H24 x D30 mm |
WARRANTY
To claim under this warranty, take this product to the Front Service Desk of your nearest Supercheap Auto store. For store locations, visit www.supercheapauto.com.au . You will need your receipt or proof of purchase.
