Table of contents
show
Zyxel POE12-30 Watt Power Injector Series User Manual
Safety Warnings
- Do NOT use this product near water, for example, in a wet basement or near a swimming pool.
- Do NOT expose your device to dampness. dust or corrosive liquids.
- Do NOT store things on the device.
- Do NOT install, use, or service this device during o thunderstorm. There is a remote risk of electric shock from lightning.
- Connect ONLY suitable accessories to the device.
- Do NOT open the device or unit. Opening or removing cavers can expose you to dangerous high voltage points or other risks. ONLY qualified service personnel should service or disassemble this device. Please contact your vendor for further information.
- Place connecting cables carefully so that no one will step on them or stumble over them.
- Always disconnect all cables from this device before servicing or disassembling.
- Use ONLY an appropriate power adaptor or cord for
Connecting the PoE Injector
- Connect an Ethernet device to the IN port of the PoE injector.
- Connect a PoE-enabled device to the OUT port of the PoE injector.
- Use the included power cord to connect the PoE Injector’s power socket to a power source (wall outlet or power strip).
LEDs
Wall Mounting (Optional)
Troubleshooting
The PWR LED is off and/or power is not being supplied to my PoE-enabled device.
- Check to see that the power cord is securely connected to the PoE Injector and an appropriate power source. Make sure the power source is on and functioning properly,
- Refer ta the Connecting the PoE Injector section. Check that the Ethernet cables are connected properly and that you ore using the correct type of Ethernet cable. Contact your local distributor if the problem persists.
FCC STATEMENT
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
