Polaris ALPHA-iQ Inground Pool Vacuum Robot User Manual

Polaris ALPHA-iQ Inground Pool Vacuum Robot User Manual

Before You Start
This Quick Start Guide contains essential installation and startup instructions. Read the complete manual and all safety warnings before commencing installation.

Contents

Connect the Floating Cable

DO NOT USE AN EXTENSION CORD. Never turn on the cleaner unless it is fully submerged in the water. Doing so may void the warranty and may cause severe damage to the cleaner motors

Submerge Robotic Cleaner in Pool

Wait for the bubbles to stop completely, then let the cleaner sink to the bottom of the pool.

The ideal entry point in the pool.

Install iAquaLink®
Before you begin installing iAquaLink, make sure you have the following:

• Robotic Cleaner submerged in the pool.
• Control Box connected and plugged into a GFCI outlet.
• Wi-Fi and Bluetooth-enabled smart device (phone or tablet).
• Wi-Fi router with sufficient signal strength at the Control Box.
• IMPORTANT: Have your Wi-Fi network password available.

Configure the System

• After logging into the iAquaLink® app, press the plus icon (+) at the top of My Systems.
• When prompted, press the connect button on the Control Box to begin pairing.
• Bluetooth® light indicates status: BLINKING – searching for signal SOLID – paired with the phone.
• Follow the on-screen prompts to connect to Wi-Fi. Wi-Fi lightindicates status: BLINKING – connected to router SOLID – connected to the internet.

Control Box

• The cleaner is receiving power.
• Start/Stop cleaning.
• Select cleaning mode:
  
  1. Waterline only (45 min)
  2. Quick Clean (1h 15 min) Floor only
  3. SMART Cycle (Calculate custom clean duration) Floor, Wall, Waterline

1. Dirty canister indicator
2. Remove cleaner from the pool
3. + / – 15 minute increments
4. Initiate connection and set up iAquaLink® control
5. Bluetooth connection status: BLINKING – searching for signal SOLID – paired with a phone
6. Wi-Fi connection status: BLINKING – connected to router SOLID – connected to the internet
7. Set recurring cleaning: Every: Day, 2 Days, or 3 Days

Proper Removal from Poo

• Use the Lift System, from either the App or the Control Box

Remove the cleaner from the pool using the handle:

Unplug & Untangle

Clean Filter Canister

• Remove
• Empty
• Rinse

NOTE: Never lift the cleaner out of the pool by the floating cable

Zodiac Pool Systems LLC

• 2882 Whiptail Loop # 100
• Carlsbad, CA 92010, USA
• PolarisPool.com | 1.800.822.7933

Zodiac Pool Systems Canada, Inc.

• 2-3365 Mainway
• Burlington, ON L7M 1A6, Canada
• PolarisPool.ca | 1.800.822.7933

A Fluidra Brand
©2023 Zodiac Pool Systems LLC. All rights reserved. Polaris® and the Polaris 3-wheeled cleaner design are registered trademarks of Zodiac Pool Systems LLC. Apple and the Apple logo are trademarks of Apple, Inc., registered in the U.S. and other countries. AppStore is a service mark of Apple, Inc., registered in the U.S. and other countries. Google Play and the Google Play logo are trademarks of Google LLC. All other trademarks referenced herein are the property of their respective owners.

REFERENCE LINK

https://www.polarispool.com/en/products/pool-cleaners/robotic-pool-cleaners/polaris-alpha-iq