Secrui-PR3-Motion-Sensor-Alarm-feature

Secrui PR3 Motion Sensor Alarm User Manual

Secrui-logo

Secrui PR3 Motion Sensor Alarm User Manual

Secrui-PR3-Motion-Sensor-Alarm-IMG

Product Introduction

This host is a passive infrared detector, it uses digital dual-core fuzzy logic infrared control processing technology and intelligent analysis algorithm ,it can effectively distinguish the interference signal and the human motion signal to prevent false alarm .This host can connect the remote control and the performance is suitable and reliable .It suitable for large villas, office buildings, clubs leisure centers, hotels families, shops. etc.

Package

  • PIR Alarm unit(s)
  • Remote control(s)
  • Warranty card
  • AAA alkaline batteries

Secrui-PR3-Motion-Sensor-Alarm-fig1

Feature

  • 5 tunes optional.
  • 4 level of adjustable volume. The remote control can control all the function

Operating Instructions

PIR Alarm Unit Setting

  • Setting
  • Short press ‹ 2s shift Arm and Disarm, beep once means Arm, beeps twice means Disarm.

Secrui-PR3-Motion-Sensor-Alarm-fig2

  • Long press ›55 from on to off, it will beeps once, from off to On, it will beep once continuously

 

  • Setting music

Short press Choose different ring tone.

Secrui-PR3-Motion-Sensor-Alarm-fig3

  • Setting light

Short press Change volume cycle adjustment.

Secrui-PR3-Motion-Sensor-Alarm-fig4

NOTE: Was, the host bate des the one even you triggers any button on the

Remote Control Setting

Secrui-PR3-Motion-Sensor-Alarm-fig5

Switch On/off to control the PIR alarm power

Secrui-PR3-Motion-Sensor-Alarm-fig6

Secrui-PR3-Motion-Sensor-Alarm-fig7

When it reach Maximum volume and minimum volume the PIR detector will be beeps twice.

Secrui-PR3-Motion-Sensor-Alarm-fig8

Factory Settings

Secrui-PR3-Motion-Sensor-Alarm-fig9

  • Plug and long press music and bulb until it will Beep once, it will turn to the first tune and biggest volume.

Secrui-PR3-Motion-Sensor-Alarm-fig10

Low Power Prompt

  • When the voltage is lower than a certain value, the button on the host or the remote control is triggered, the indicator light flashes 3 times, and there is no voice prompt, it indicates that you should change the battery or plug in USB power.
  • when the battery voltage is too low, it will shut down automatically.

Attention

  • Please use Alkaline or rechargeable battery do not mix the new and old battery to use
  • Non-professionals are not allowed to repair.
  • Do not install the product in a place where it is exposed to rain, long periods of direct sunlight, and where temperature will change rapidly.

Technical Parameters

  • Working voltage: USB 5V or 3’AAA Alkaline battery
  • Standby current: <300uA
  • Working current: ‹100mA.

REFRENCE LINK

Leave a Reply