Uniden PRO501HH Handheld CB Radio User Guide
INTRODUCTION
The PRO501HH radio is a mobile radio designed for use in the Citizens Band (CB) Radio Service. It will operate on any of the 40 AM frequencies authorized by the Federal Communications Commission (FCC). Your radio features a super heterodyne circuit with Phase Locked Loop techniques to assure precise frequency control.
FEATURES
- 40 AM channels
- 10 Weather channels
- Dual Channel Watch
- Full Channel Scan
- Instant Channel 9/1
- High/Low power saver switch (HI = 4W; LOW = 1W)
- Key lock
- Backlight On/Off
- Condenser microphone.
- Ceramic filter: Delivers greater selectivity and reduces adjacent channel interference.
- AGC (Automatic Gain Control) for a constant sound level.
- Automatic modulation control for a constant audio transmit modulation level.
- Low distortion IC audio circuit.
- Automatic noise limiter to reduce pulse noise.
- Antenna with BNC connector.
- External speaker jack and external MIC jack
- Jack for external power source and battery charger.
- Rechargeable (9 AA Ni-MH) or Alkaline (9 AA) batteries (not included)
SAFETY NOTICE
- Do not expose the PRO501HH to water or extreme temperatures.
- Do not leave batteries installed over a long period of time as leakage may occur and cause damage to the radio.
- Never use different batteries from the ones suggested.
- Never use harsh chemicals to clean this radio. Use a damp soft cloth.
UNIDEN CONTACT INFORMATION
You can get answers 24/7 at our website: www.uniden.com.
INCLUDED IN YOUR PACKAGE
If any of these items are missing or damaged, immediately contact your place of purchase or www.uniden.com.
Not shown: Wrist Strap, Charge Adapter
PARTS OF THE RADIO
NOTE: FCC rules reserve Channel 9 for motorist assistance and other emergency communications. Channel 9 should only be used in( situations where there is immediate danger to the safety of individuals or the protection of property.
Make sure you have read and understood part 95 of the FCC rules and regulations before using the transmitter.
LCD
SETUP
INSTALL
Install the included rubber antenna onto the radio.
CAUTION: Make sure the SWR is less than 2:1 before using the radio. An SWR higher than 2:1 can damage the transmitter.
This radio transmitter 513C-UT422 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
CONNECT TO POWER
Your PRO501HH can operate on DC power or batteries.
DC Power
- Plug DC power cable into the PRO501HH.
- Plug the other end into your vehicle’s cigarette lighter/DC power conversion plug.
Battery Power
You can use either 9 non-rechargeable alkaline batteries or 9 rechargeable Ni-MH batteries (not included) with this unit.
- Open battery cover.
- Insert the 9 batteries according to the directions indicated inside the battery compartment.
- Close battery cover.
Charge the Radio
NiMH rechargeable batteries are not fully charged when first installed in the radio. After installing the rechargeable NiMH batteries for the first time, place the radio in the charge adapter. Let it charge for about 12 hours or until the LED on the charge adapter turns green. Regardless of which type of batteries you use in this radio, the battery icon flashes when power is low. Replace the alkaline batteries recharge the unit if using the rechargeable NiMH batteries
Low Power Indication
The battery icon shows a reduced power level and its outline flashes. Connect the DC power cable to a power source and to the radio to continue to use it until you can recharge/replace the batteries.
CONNECT EXTERNAL SPEAKER
Your radio supports an external speaker for remote monitoring. The external speaker is sold separately.
OPERATION
KEY BASICS
BASIC OPERATION
CB OPERATION
CB Communication Codes
The “10” code allows you to communicate easier in noisy environments. The following table lists some of the most common codes and their meaning.
EMERGENCY OPERATION
The Pro501HH provides instant access to emergency channels 9 and 19. Press 9/19 DUAL once for channel 9; press it twice for channel 19. Press 9/19 DUAL a third time to return to the original channel.
DUAL WATCH
Dual Watch lets you monitor two channels at the same time for incoming transmissions.
Programming Dual Watch Channels
- Select a channel using the ▲ or ▼ keys.
- Press and release PROG key. The Program icon displays.
- Press and hold DUAL key until the radio beeps. The Program icon disappears and the DW icon flashes.
- Select another channel using the ▲ or ▼ keys.
- Press and release DUAL; the radio beeps and the DW icon stays on.
- The LCD switches between the two channels selected as it monitors both for transmissions.
- Press ▲ or ▼ to exit Dual Watch mode.
AUTOMATIC NOISE LIMITER
Automatic Noise Limiter (ANL) suppresses white noise. Press ANL to turn it on. ANL does not function when the radio is in WX mode.
WEATHER
The PRO501HH accesses 10 weather channels.
- Press and release CB/WX key. The WX icon and the current weather channel display.
- Select a different weather channel using the ▲ or ▼ keys.
- Press and release CB/WX key to return to normal CB operation. The WX icon disappears.
MAINTENANCE
Clean the unit with a damp cloth only; never use harsh chemicals.
TROUBLESHOOTING
If your radio is not performing to your expectations, please try these simple steps. If these steps don’t solve your problem, visit the Uniden website (www.uniden.com) for troubleshooting and FAQ information.
SERVICE AND REPAIR INFORMATION
- Save your purchase receipt for proof of warranty.
- When ordering parts, it is important to specify the correct model number of this radio (PRO501HH).
- It is the user’s responsibility to make sure the radio is operating in accordance with the FCC Citizens Radio Service regulations at all times.
FREQUENCY LISTS
CB CHANNEL FREQUENCY LIST
SPECIFICATIONS
FCC PART 15 & IC COMPLIANCE
FCC Compliance Statement: This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
ONE-YEAR LIMITED WARRANTY
WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”)
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for this product.
DOWNLOAD PDF LINK
