SereneLife PSLHTM30 Electric Leaf Blower Manual
WARNING! When using electric garden tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury.
IMPORTANT SAFETY INSTRUCTION
READ ALL INSTRUCTIONS BEFORE USING THIS BLOWER/ VACCUM
WARNING – To reduce the risk of fire, electric shock or injury
- When servicing use only identical replacement parts.
- To reduce the risk of electric shock, this appliance has a polarized plug (one blade Is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If the plug does not fit fully into the wall outlet, reverse the plug If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way.
- Avoid Dangerous Environment Don’t use appliances in damp or wet locations.
- Don’t use while raining.
- Keep Children Away! All visitors should be kept at a distance from work area.
- Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts. Use of rubber gloves and substantial footwear is recommended when working outdoors. Wear protective hair covering to
contain long hair. - Use Safety Glasses – Always use face or dust mask if operation is dusty.
- Use Right Appliance – Do not use appliance for any job except that for which it is intended.
- Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) to be used for the gardening appliance.
Work area
- Keep work area clean and well lit. Cluttered and dark areas invite accidents.
- Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
- Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
- Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock.
- Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electrical shock if your body is earthed or grounded.
- Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
- Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
- When operating a power tool outdoors, use an outdoor extension cord suitable for outdoor use. Use of acordsultable for outdoor use reduces the risk of electric shock.
Personal Safety
- Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use power tool while you’re tired or under the infiuence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury.
- Use safety equipment. Always wear eye protection. Safety equipment such as a dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries.
- Avoid accidental starting. Ensure the switch is in the off-position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents.
- Remove any adjusting key or wrench before turning the tool on.
A wrench or a key that is left attached to a rotating part of the power tool may result in personal injury. - Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations. - Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
- If devices are provided for the connection of dust extraction and collection facilities ensure that these are connected and properly used. Use of these devices can reduce dust related hazards.
Power tool use and care
- Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed.
- Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and must be repaired. - Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
- Store idle power tools out of the reach of children and do not allow persons. Unfamiliar with the power tool or these instructions to operate the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users. - Maintain power tools. Check for misalignment or binding of moving parts breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
Description
- Main handle
- Upper blow tube
- Lower blow tube
UNPACKING
This product requires assembly
- Carefully remove the product and any accessories from the box.
Make sure that all items listed inthe packing list are included. - Inspect the product carefully to make sure no breakage or damage occurred during shipping.
- Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
- If any parts are damaged or missing please call Customer service for assistance.
Blower Function
Assembly
- Plug upper blow tube 2 into lower blow tube 3 (fig. A-1)
- Plug lower blow tube 3 into main handle (fig. A-3)
Start-up
- Each time before you use the device, check that the mains plug and mains lead are undamaged.
- Insert the extension cable into the strain relief
- Move the switch to position 0,
- Plug in the mains plug.
Switch ON
Point the suction tube downwards when operating the device.
We recommend running the mains lead towards the rear over your shoulder
OPERATION
WARNING – Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to infect serious injury.
WARNING – Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING – Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
- Clearing leaves and other yard debris from your lawn
- Keeping decks, patios, garages and driveways free from leaves, pine needles and other debris
STARTING/STOPPING THE BLOWER
Attach the outlet end of an extension cord to the plug on the rear of the blower.
NOTE: Use only approved outdoor extension cord as described previously in this manual.
Route the extension cord through the side of the loop located on the rear of the blower housing and place underneath the cord retainer.
OPERATING THE BLOWER
- To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile.
- To reduce sound levels, limit the number of pieces of equipment used.
- Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when water is available.
- Watch out for children, pets, open windows, or freshly washed cars, and safely blow debris away.
- Hold the blower with the handle in your right hand.
(Proper operating position is shown in figure 12.) - Operate power equipment at reasonable hours only– not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordinances.
- After using blowers or other equipment, CLEAN UP! Dispose of debris properly.
- Attach the outlet end of an extension cord to the plug on the rear of the blower.
- NOTE: Use only an approved outdoor extension cord as described previously in this manual.
- Route the extension cord through the side of the loop located on the rear of the blower housing and place underneath the cord retainer.
MAINTENANCE
- WARNING – When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
- WARNING – Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes, resulting in possible
serious injury. - WARNING – Before inspecting, cleaning or servicing the machine, unplug the power cord and wait for all moving parts to stop. Failure to follow these instructions can result in serious personal injury or property damage.
- WARNING – Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic, which may result in serious personal injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean clothes to remove dirt, dust, oil, grease, etc.
STORAGE (1 MONTH OR LONGER)
- Clean all foreign materials from the blower.
- Store indoors in a place that is out of reach of children. Keep away from corrosive agents such as garden chemicals and de-icing salts.
TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION |
Material is not sucked in properly (reduced vacuuming power) | 1. Machine is clogged or blocked 2. Bag too full 3. Speed setting too low (only for garden vacuum with fully variable speed control) 4. Extension cable too long, or cross-section too small. Socket too far away from main connection, and cross- section of connection lead too small. | 1. Empty bag 2. Adjust to higher speed 3. Extension cable at least 16AWG, maximum 25 meter long. Cross-section of at least 14AWG in longer cables. |
Unit can’t blow or suck debris | 1. Bag full 2. Blocked tube 3. Blocked impeller 4. Dirty bag 5. Torn bag 6. Bag unzipped 7. Unit unplugged | 1. Empty the bag. 2. Clear the blockage. 3. Clear the blockage 4. Clean the bag. 5. Replace the bag. 6. Zip up the bag. 7. Plug into an outlet or an extension cord |
Unitwill not start | 1. Unit is unplugged. 2. Power/speed switch is in the OFF position. 3. Defective power switch. 4. Vacuum tubes are not correctly installed. 5. Intake port/cover is not closed. 6. House circuit may have tripped. 7. Connection lead defect. | 1. Check cord to make sure it is plugged into an electrical outlet. 2. Slide switch to high or low. 3. Check vacuum tubes to ensure that they are allowing the switch to be engaged when correctly installed. 4. Ensure that port/cover is fully closed an locked. 5. Check wall circuit breaker panel and reset if necessary. 6. Check fuse (10 A) 7. Replace lead or have lead checked (electrician) Never use defect lead 8. To solve the problem, contact the manufacturer or an authorized company (see customer service list) |
DISPOSAL
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
Features
- Home& Backyard Corded Blower
- High-Powered Blower Motor
- Simple Electric Plug-in Operation
- Light weight, Handheld Design for Mobility
- Integrated Handle for One-Handed Operation
- Rugged& Heavy-Duty Design
- Blow Tube Disassembles for Easy Storage
- Perfect for Lawns, Gardens, Back Yards, Walkways, Landscapes
What’s in the Box
- ElectricLeaf Blower
- BlowTube Assembly, 2-Pc.
Technical Specs
- Power Output: 6Amp
- Wind Speed/Blower Power: Up to 135 MPH,14K RPM
- Engine Type: Single Speed Brush Motor
- Noise rating: 99dB
- Construction Material: Engineered ABS
- Power Cable Length: 0’ ft
- Power:120V
- Total Assembled Dimensions (L x W x H): 6’’ x 7.3’’ x 9.6’’ -inches
- Sold as: 1