Givebest PTC-905A Ceramic Space Heater User Manual
IMPORTANT SAFETY INSTRUCTIONS
DANGEROUS VOLTAGE:
The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral intended for the user to the presence of important operating and maintenance(servicing) instructions in the literature accompanying the appliance.
YOUR RESPONSIBILITIES
Electrical appliances may expose people to hazards that can cause severe injuries as well as death. The use of electrical products may create hazards that include but are not limited to, injury, fire, electrical shock, and electrical system damage. These instructions are intended to provide you with the information you need to use the product and to avoid such hazards. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons including the following:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch surfaces, use handles when moving this heater.
- Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep sides and rear
- Extreme caution is necessary when any heater is used by or near children or invalids, and whenever the heater is left operating and unattended.
- Always unplug the heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions or has been dropped or damaged in any manner Returnheatertomanufacturer has been dropped or damaged in any manner. Discard the heater or return the heater to the authorized service facility for examination and/or repair.
- For residential use only.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate the heater where it may fall into a bathtub or other water container.
- Do not run a cord under the carpeting. Do not cover the cord with rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrangecordawayfrom-traffic area and where it will not be tripped over.
- Children should be supervised to ensure that they do not play with the appliance. Do not use outdoors.
- Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any combustible materials. DO NOT use onanunstablesurface such as bedding or deep carpeting. Be sure the heater is not in a position where it may be tripped over by small children or pets. The heater’s rubber feet will hold it firmly in position.
- If your home has aluminum wiring have a licensed electrician check your receptacle connections. When using a 1500-watt heater, aluminum wire connections issue.
- Before cleaning, storage, or when not in use, turn the product’s control unplug the heater from the electrical outlet, and allow cool.
PRODUCT OVERVIEW
- Power Indicator
- Overheat Sensor
- Heating Output Area
- Tip-over Switch
- Handle
- Fan and Ventilation Area
- AC Power Cord
- Manual Temperature Control Knob
- Mode Setting Knob
OPERATIONS
- Read the user manual carefully and keep it for future reference.
- Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or any combustible material.
- Make sure the Power/Mode Setting Knob pointing to the “OFF” position before plugging the heater into the outlet.
- Plug into a polarized AC 120V~ outlet.
BE SURE THAT THE PLUG FITS TIGHTLY INTO OUTLET.
When the plug fits loosely into receptacles, it may slip partially or completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater. - Turn the Manual Temperature Control Knob fully clockwise to the “+” position (highest setting) to assuring the three modes settings are activated.
NOTES: When reaching a certain comfortable temperature, slowly turn the Manual Temperature Control Knob counter-clockwise until a “click” sound is heard(about half-round of the knob circle), at this time the unit will not be cut off when meeting overheat, and the unit will not be turned on automatically after cooling down. So keep the knob on the position of the latter half-round of the knob circle, if set to the front half-round knob circle, the modes setting also can not be used. If set to the “-” position, the unit will be turned off. - Select the proper setting to accommodate your comfort level with the Power Knob. The Power/Mode Setting Knob is equipped with three(3) mode settings, “I” (750W), “II” (1500W) and FAN( Natural Wind) . You can select the proper setting to accommodate your comfort level with this Knob.
- After heating, turn the Power/Mode Setting Knob to the “FAN” position to cool down the heater, then turn to the “OFF” position and unplug the heater.
OVERHEAT PROTECTION
- A thermal overload protector is built in at the top of the heating panel, if the heater is obstructed or blocked at the front panel and rear ventilation panel by the curtain, drape cotton sheet, etc., the thermal overload protector activates to prevent overheat.
- When the internal temperature of the heater reaches up to 70 Celsius which may cause a fire hazard, the heater will be shut off automatically. It can ONLY resume operation when the user resets the unit.
To Reset Heater:
- Unplug the heater and wait about 15 minutes until the heater cools down.
- After the heater has cooled down, plug the unit into a 110-120V electrical outlet again and follow the operation instructions described in this manual.
TRIP-OVER PROTECTION
A tip-over switch is placed at the bottom of the heater, when the heater is taken away or knocked over by pets or humans, the heater will be shut off automatically to prevent burning combustible materials.
MAINTENANCE
Daily Maintenance:
- Before cleaning, turn OFF the heater unplug it from the electrical outlet, and wait for it to cool down.
- Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor and heating panel.
- Do not immerse the heater in water.
- Never use gasoline, benzene, or thinner. This will damage the surface of the heater.
- After cleaning, be sure to completely dry the unit with a cloth or towel.
Storage Maintenance:
- Store the heater in a cool and dry location with the power cord properly secured. Please store the heater in its original carton or a suitable container.
FAQ
Q: What should I do if I have questions about this heater?
A: Please feel free to contact us by the contact info at the end of this manual.
Q: Are there any overheating protection measures?
A: Yes. A thermal overload protector is built in this heater. If the heater is overheated, it will automatically shut off, it’s a safety protection. When this situation happens, pull out the plug for 15-30 minutes and plug in again to restart the heater thermal overload protector.
Q: If the heater is tripped over, will it automatically be shut down?
A: Yes. There is a tip-over switch at the bottom of the heater, when the heater has been lifted and leaves from its position or is tripped over, it will be automatically shut off.
Q: Why does sometimes the heater suddenly shut off and even the power indicator went out?
A: In this situation, please refer to the “TRIP-OVER PROTECTION ” and OVERHEAT PROTECTION” parts
SPECIFICATIONS
| Model | PTC-905A |
| Voltage | AC 120V~ |
| Heating coverage | 200 sq.Ft |
| Weight | 4.23 pounds |
| Dimension | L(9.6″) * W(6.1″) * H(11″) |
| Material | ABS+PA+Metal |
ONE-YEAR LIMITED WARRANTY
You should first read all instructions before attempting to use this product.
- A. This 1-year limited warranty applies to the repair or replacement of a product found to be defective in material or workmanship. This warranty does not apply to damage resulting from commercial, abusive, unreasonable use, or supplemental damage. Defects that are the result of normal wear and tear will not be considered manufacturing defects under this warranty. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights that vary from jurisdiction to jurisdiction. This warranty applies only to the original purchaser of this product from the original date of purchase.
- B. This warranty does not cover damage resulting from any unauthorized attempts to repair or from any use not per the instruction manual.
- C. Please be sure to specify a model number and order ID.
NOTE:
IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER SERVICE FIRST OR SEE YOUR WARRANTY. DO NOT RETURN THE HEATER TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.
