Diretv RC66RX Universal Remote Control Quick Reference Guide
RC83V remote works in IR and Bluetooth interface. The remote uses Bluetooth 2‐way communication to C71KW. Bluetooth eliminates the need for the remote and the paired devices to be in line of sight to each other. Voice Recognition is available in the RC83V Remote. Voice search will only work when the remote is paired to the C71KW.
Pairing your remote to Set top Box
To pair the DIRECTV remote control to the STB, perform the following steps:
- Press and HOLD Rewind and Fast Forward at the same time for 3 second until the visible LED’s starts flashing.
- Enter digits 961 follow by CH up key.
- Using the number keys enter the last six digits of the RID number located behind the STB.
- Press and release ENTER key (the green light flashes twice).
Clearing Pairing
Press and hold Dash and APPS at the same time for 3 seconds until the LED’s flash. The RCU will unpair from the STB.
RESTORING FACTORY DEFAULT SETTINGS
To reset all the functions of the remote control to the factory default settings following these steps:
- Press and hold MUTE and Exit at the same time until the RED LED turns ON.
- Using the number keys, enter 9‐8‐1. (The feedback flashes 4 times).
COMPLIANCE WITH FCC RULES AND REGULATIONS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
- The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
SETUP CODES FOR TV’s
To reset all the functions of the remote control to the factory default settings following these steps
DOWNLOAD PDF LINK
b210fbe4021f32f200c79758532cb0a359f2bb7e0c8766ce702570317153dc40_optim
