https://www.pulsarvaporizers.com/collections/electric-dab-rig-rok

PULSAR RöK Electric Dab Rig Full Spectrum User Manual

PULSAR logo

PULSAR RöK Electric Dab Rig Full Spectrum User Manual

PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-prduct-img

RöK OVERVIEW & FEATURES

PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-1

KIT INCLUDES

PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-2

KIT ALSO INCLUDES Charging Cable, Crud Bud™* Alcohol Cotton Buds, Wire Brushes, and Dabber Too.

RöK QUICK START GUIDE
Please read the instructions in full prior to use. Failure to do so may void the warranty.

  • Do not use ceramic cup coil for concentrates.
  • RöK will blink Yellow 3 times if…
    • The coil is not properly connected, or no coil is attached.
    • The coil’s life has expired.
    • There is a short circuit.
    • The unit is overheating.
  • Do not blow into the unit. This will force water into the core of the unit and may cause a short circuit,
  • Do not tilt, drop, or lay the unit on its side as this will allow water into the core of the unit.
  • Do not allow water in the atomizer.
  • Do not store the RöK with water in the beaker. Always empty prior to storage.
  • Attach and detach all glass parts with care. Do not force.
  • Do not use RöK Mode for more than 4-5 consecutive sessions to avoid excessive heat transfer.
  • Allow for a 1-2 minute cooldown time between sessions.
  • Keep away from extreme heat & cold.
  • Keep away from excessive moisture, and do not immerse in liquid.

GET STARTED

PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-3

  1. Charging – Make sure your device is 100% charged (approx, 2 hours) for the best RöK experience. The device will pulse Red when charging and display Green when charging is complete. Do not overcharge. The RoK displays battery life when turned on, flashing 3 times: Green = Full Charge, Yellow = Med, Red = Low. Total Estimated RöK Sessions = 25-30 (Based on the Green setting on RöK mode. Results will vary according to user preference & mode/time selected.)
  2. Adding Water – Fill the Rö beaker base with water. We recommend filling to the halfway point of the beaker base. But feel free to add less water to achieve your preferred percolation. Do n overfill past the halfway point.
  3. Downstem Perc Attachment – Gently attach the RöK disc perc downstream to the opening found between the 2 metal air path tubes. Inse with a slight, twist motion and secure the perc flush inside the silicone housing. Do not force, or place high pressure onto perc when affixing to the unit.
  4. Beaker meets RöK – Set Rök beaker base (with the desired amount of water) onto a level, solid surface. Gently place the RöK body onto the beaker base aligning the lip of the beaker base with the silicone track found on the bottom of the RöK body, Once lined up, gently press down at a slight angle, simultaneously applying a rolling pressure to the RöK body so that lip and track attach and lock into place. The fit should be snug and secure. Do not force, or place high pressure on the beaker base.
  5. Power Up – Press the Dab Trigger 5 times to turn on the RöK unit.
  6. Temp Select – Press the Dab Trigger 3 times to cycle through each temperature cycle.
    ÖK TEMPERATURE /TIME GRAPH
    PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-4
  7. Cold Start Preferred – Now that your Rök is powered on and your preferred temp is selected, locate the Rök dabber to place your desired amount of concentrate into the quartz cup. Make sure to place the product on the bottom of the cup and not the sides.
  8. Pre Heat Function – Press and hold the Dab Trigger for 5-15 seconds to preheat your product to your desired preference,
  9. Carb Cap – Place your RöK oil carb cap onto the silicone collar,
  10. RoK Out – You have the ability to control the power to reach your desired vapor density, Press and hold, or “Pulse,” the Dab Trigger to fire the Rök to your desired preference. The unit will time out after the Dab Trigger is held for 30 seconds. Get creative with your RöK timing to personalize the experience. RöK Mode – For a more hands-free experience, once your temp is selected and carb cap positioned, press the Dab Trigger 2 times to activate Rök Mode.
  11. RöK Mode will activate the preselected temp for a total of 30 consecutive seconds. To stop RöK Mode once activated, simply press 2 times to end RöK Mode.
  12. Flower Mode – Included with your RöK is a ceramic coil cup for dry herb, combustion use, as well as a dry herb carb cap. At the lowest temperature setting, the ceramic dry herb coil produces a vape-like experience. The higher settings produce a more traditional dry herb water pipe experience. Simply around vour flower, and pack it into a ceramic herb cup. DO NOT use the ceramic cup with concentrates, the air holes in the cup will cause leaks. Once packed with flowers, lightly tamp the flowers down. Place RöK herb carb cap in place and enjoy. Get creative with your RöK settings to personalize the experience. Start off at the lowest setting for a lighter cloud, and work your way up the temp settings until the desired effect is achieved. Keep in mind, that you can ” Pulse” the Dab Trigger to stoke your cherry.

RöK CLEANING

CAUTION!
ALLOW ALL PARTS OF THE ROK TO COOL BEFORE DISASSEMBLING AND CLEANING.

  1. Coil Cup Cleaning – For optimal use and flavor, wipe out your cups with a cotton-tipped swab after each session, Alter every few sessions, it is recommended to additionally clean the cups by wiping with included Crud Bud™* alcohol-filled cotton buds until clean to preserve the quality of product and lengthen the life of your coils. This can be done with the coil cups attached, but allow them to cool fully before touching. Never immerse your coils in a cleaning solution. Make sure to wipe up any residual solvent left in the cup.
  2. All RöK glass parts – To remove glass parts from the RöK, follow step 4 in reverse. It is recommended to clean with 91% or above isopropyl alcohol. Once clean, rinse with cold water and allow to air dry before reassembling.
    PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-5
  3. Air Path Ways – With the glass down stem removed, pull both metal air path tubes out of the silicone housing and soak them with 91% isopropyl alcohol. Use the included cleaning brush to remove stubborn clogs, Once clean, rinse with cold water and allow to air dry, For further air path cleaning, disassemble the RoK collar and remove the coil. Also, remove the mouthpiece and silicone splash protector. Dip the cleaning brush into the alcohol solution and proceed to clean both air pathways that hold the metal air path tubes. Rinse the brush free of alcohol, and with a water-wet brush, repeat cleaning air paths.
  4. Mouthpiece – Remove the metal mouthpiece and silicone splash guard insert. Clean both items with mild soapy water and allow them to air dry. Be sure to insert a silicone guard by following the track line within the RöK mouthpiece cavity. CAUTION, If a silicone guard is not inserted correctly, it can become pinched and hinder air flow.
    PULSAR-RöK-Electric-Dab-Rig-Full-Spectrum-User-Manual-fig-6
  5. Periodically, clean the 510 connection of the atomizer with an alcohol cotton swab, and allow it to fully dry before re-attaching the coil.
RöK PRO TIPS
  1. Utilize RöK Mode for hands-free operation and for sessions with multiple individuals.
  2. For a better experience, slowly rotate the carb cap while inhaling to get the fullest dab of your product,
  3. Place concentrate on the bottom of the quartz cup and not the sides.
  4. Divapor sill anton i recoil ended oil maxim umillanctially decrease the amount
  5. Get creative. Tailor your sessions to your liking with the fire button. Select temp mode, press and hold the Dab Trigger, or “Pulse” at will for your perfect session.

WARRANTY

Important Safety Warnings:
Do not be exposed to extreme temperatures or direct sunlight. Do not drop the Pulsar Rok or Pulsa brand Charge sand Ular brand ace series. Pulsa Mocks then et for it’s on not submerge provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. Pulsar RöK is not a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease, or other conditions. pregnant or breasteng. tate to toil any of these instructions could result in product damage, property damage, or personal injury

Limited Warranty:
Pulsar RoK is guaranteed from manufacturer defects or malfunction from the original date of purchase for a period of 1 year. This limited warranty protects against manufacturer defects under normal use and improper cleaning, legal or any other damage that, is not a rental directive material or workmanship, if jon liquid,

Materials reuse must provide a coil in original date sures feet and may be required to provide shipping to return defective parts or materials. We intend to complete all repairs/replacements within 7 business days, although proper use of a device election stain re proper use an uma, or twit vote the worsen. The warranty is non-transferable. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. For warranty servicing, contact us at: PulsarVaporizers.com

REFERENCE LINK

Leave a Reply