Shark LV900 Cordless Pet Perfect® XL User Manual
IMPORTANT SAFETY INSTRUCTIONS
- DO NOT use, charge or store the hand vacuum outdoors or on wet surfaces. Store the cordless vacuum indoors. Put the vacuum away after use to prevent accidents.
- Use only as described in this manual.
- DO NOT allow it to be used as a toy. Close attention is necessary when used by or near children. DO NOT leave the vacuum unattended while in use.
- DO NOT handle the plug, charger, or appliance with wet hands.
- Fully assemble the hand vacuum before operating. DO NOT use a hand vacuum cleaner without a dust cup filter in place. Use only on dry, indoor surfaces.
- DO NOT use the charger with an extension cord. Plug the charger directly into an electrical outlet. Use a charger only in a standard electrical outlet.
- DO NOT attempt to use the charger with any other product nor attempt to charge this product with another charger. Use only the charger model ZD6W210024US supplied with this appliance.
- DO NOT use the charger with a damaged cord or plug. If a charger or hand vacuum has been dropped, damaged, left outdoors, or dropped in water, return it to EURO-PRO Operating LLC for examination, repair, or adjustment.
- DO NOT abuse the charger cord, pull the cord around sharp edges or corners, or close the door on the cord. Never carry the charger by the cord or yank to disconnect from an outlet; instead, grasp the plug and pull to disconnect. Keep the charger cord away from heated surfaces.
- Use only the manufacturer’s recommended attachments. Always turn off this appliance before connecting or disconnecting the motorized nozzle. DO NOT attempt to change accessories while the unit is running.
- Use extra care when cleaning on stairs.
- Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
FEATURES
- An Air-Intake Nozzle
- B Dust Cup Container
- C Dust Cup Filter
- D Dust Cup Release Button
- E Charging Indicator Light
- F On/Off Switch
- G Motor Housing
- H Charging Adapter
- I Motorized Brush
- J Crevice Tool
- K Dusting Brush*
*Accessories vary by model
TECHNICAL SPECIFICATIONS:
14.4 Volt MAX** lithium-ion battery ** The lithium-ion battery, like all lithium-ion products, will naturally decrease in capacity over time from the 100% capacity of a new battery.
ASSEMBLING THE HAND VACUUM
IMPORTANT: The dust cup filter must always be used when operating the hand vacuum.
- Push the dust cup release button and remove the dust cup.
- Verify that the dust cup filter is inside, then reattach the dust cup to the hand vacuum.
- The motorized brush can be used to vacuum short-pile carpets or rugs. To attach the motorized brush, make sure the On/Off switch is in the Off position. Then firmly insert the motorized brush into the air-intake nozzle, ensuring that the contact pins are engaged in the connector slots of the unit. WARNING: Do not touch the motorized brush while it is in motion.
- The crevice tool can be used to clean narrow, hard-to-reach places. To attach the crevice tool, insert the attachment into the air-intake nozzle.
CHARGING YOUR HAND VACUUM
- Connect the charging adapter to the port on the back of the vacuum.
- Plug the charger into a wall outlet. The charging indicator light will illuminate when the vacuum is being charged. NOTE: lithium-ion battery takes approximately 6 hours to charge completely.
MAXIMIZING THE LIFE OF YOUR LITHIUM-ION BATTERY
Your lithium-ion battery does not come fully charged. Prior to first use, charge completely. During first use, discharge fully to condition your lithium-ion battery. Failure to do so may cause LED indications to work incorrectly.
USING THE CORDLESS VACUUM CAUTION:
The air-intake nozzle and attachments must be free of obstructions at all times, or the motor will overheat and could become damaged.
- To start the vacuum, slide the On/Off switch to the On position.
- To turn off the power, slide the switch to the Off position.
CHANGING & CLEANING THE DUST CUP FILTER
NOTE: It is recommended that the dust cup filter be replaced every 6 to 9 months to ensure peak performance.
- Press the dust cup release button and pull out the dust cup.
- Carefully remove the dust cup filter and empty the dust cup.
- Hand-rinse the filter in cold water and let it air-dry completely before reinstalling. Air-dry only. DO NOT use a hair dryer or clothes dryer.
TROUBLESHOOTING
| Problem | Solution |
| The hand vacuum will not operate | Battery needs to be recharged. Battery is damaged and needs to be replaced. Try using a different electrical outlet to charge. |
| Motorized brush will not work | The metal contact pins on the motorized brush are not in contact with the connector slots on the vacuum. Remove the motorized brush and reinsert firmly into the air-intake nozzle. The motorized brush is blocked. Carefully remove all lint, hair, or other debris from the motorized brush. |
| Hand vacuum will not pick up or the suction is weak | Dust cup is full. Empty the dust cup. Dust cup filter needs cleaning or replacement. Clean or replace the dust cup filter. Vacuum needs to be recharged. |
| Dust is escaping from the hand vacuum | Empty the dust cup container. The dust cup filter is not installed correctly. Remove it and reinsert it. The dust cup filter has a hole or a puncture and needs to be replaced. |
Continued
| Light Indication | Indicator | LED Light Explanation |
| Blinking Red Light | Low Battery | When the red light indicator flashes for 5 seconds this means either the battery power is low or there is a jam in the handheld vacuum. Clear any clogs or debris buildup. |
| Red Light Fading in and Out | Vacuum Charging | To charge the handheld vacuum, connect it to a power source and turn the power on. The red light will fade in and out as the handheld vacuum charges. |
| Solid Green Light | Fully Charged | When the handheld vacuum is fully charged, the indicator light will illuminate solid green for 5 seconds, then turn off. (It takes approximately 6 hours for a full charge). |
| Continuous Flashing Red Light | Overheating/ Cold Vacuum | If the indicator light continually flashes red every second, this means the handheld vacuum is either too hot or too cold. Leave the hand vacuum to cool down for approximately 45 minutes if overheating. |
|
Solid Red Light | Low Battery | Battery may be low. To charge, connect the charging adapter to the port on the back of the handheld vacuum, plug adapter into a wall outlet, and turn on the power on the handheld vacuum. |
| Jammed | There may be a jam or a blockage. Clear any clogs or debris buildup. | |
| Wrong Charger | You may be using the wrong charger. Make sure you are using the correct charging adapter for your unit. |
PARTS
To order additional parts for your Shark® CORDLESS HAND VACUUM models LV800, LV801 go to sharkaccessories.com or call 1-800-798-7398.
TWO-YEAR LIMITED WARRANTY
EURO-PRO Operating LLC warrants this product to be free from material defects and workmanship for a period of two (2) years from the date of purchase when utilized for normal household use, subject to the following conditions, exclusions, and exceptions. The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes.
This limited warranty does not cover damage caused by misuse, abuse, negligent handling, or damage due to faulty packaging or mishandling in transit. This warranty does not cover damage or defects caused by or resulting from damages from shipping or repairs, service, or alteration to the product or any of its parts, which have been performed by a repair person not authorized by EURO-PRO Operating LLC. Non-durable parts, including, without limitation, filters, brushes, and electrical parts which normally require replacement are specifically excluded from this warranty.
If your appliance fails to operate properly while in use under normal household conditions within the warranty period, you may return the complete appliance and accessories with proof of purchase and date, freight prepaid. For customer service support, call 1-800-798-7398 or visit our website at www.sharkclean.com. If the appliance is found by EURO-PRO Operating LLC to be defective, in EURO-PRO Operating LLC’s sole discretion, we will repair or replace it free of charge. Proof of purchase date and check made payable to EURO-PRO Operating LLC in the amount of $12.95 to cover the cost of return shipping and handling must be included.
