Vornado SRTH Small Room Tower Heater User Guide
IMPORTANT SAFETY INSTRUCTIONS
This owner’s guide and any additional inserts are considered part of the product. They contain important information about safety, use and disposal. Before using the product, please familiarize yourself with all operating and safety instructions. Please keep all documents for future reference and pass these documents on, together with the product, to any future owner. See our website to view, download and print the most current version of this owner’s guide.
INTENDED USE:
This product is intended to heat and circulate the air in indoor living spaces only. This product is not intended
for commercial or industrial use. The manufacturer assumes no responsibility for damage or injury due to unauthorized use or product modification. Failure to follow these directions will void the product warranty.
SAFETY FEATURES
- Safe to touch, even on high heat setting.
- If airflow becomes blocked, power to heater is shut off to prevent overheating.
- If the heater tips over the red indicator light will illuminate until the heater is placed back in upright position.
- Resists curious fingers.
- If tipped more than 10 degrees in any direction, power is cut to heater.
CONTROLS
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact Vornado Air LLC at 1-800-234-0604.
- Use integrated handle on back of heater for lifting and carrying.
- Position heater so airflow is not obstructed.
- Plug power cord into standard grounded wall outlet.
- Select Mode by turning control dial. In Fan Only position, fan will run continuously. Press to set timer for 4 hours. LED light illuminates when Timer is set.
CLEANING
Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended on a weekly basis. If service is required, return your heater to Vornado. See WARRANTY for instructions.
- Unplug heater before cleaning.
- Use brush attachment on household vacuum cleaner to vacuum any accumulated dust off Air Inlets on back of heater.
- Use brush attachment on household vacuum cleaner to vacuum any accumulated dust off Front Angled Outlet Grill.
- Wipe down the entire heater with a soft, dry cloth.
STORAGE
During the off-season or after extended periods of non-use, you may choose to store your heater. To ensure long life of the product, it is recommended to store your heater by following these instructions:
- Unplug power cord and bundle loosely.
- Cover, or place back in retail carton if available. This will prevent heater from accumulating dust over time.
- Store heater in cool and dry location
RESET HEATER
RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multi level safety shut-off system designed to prevent overheating. Overheating may occur when the inlets or outlet are blocked. If this happens, the safety shut off system will cut power to the heater and you will need to manually reset the heater.
- Power heater off, then unplug power cord.
- Remove any obstructions.
- Wait 5–10 minutes, allowing heater to cool down.
- Plug in power cord and place heater in desired position.
- Power heater On. Your Vornado Heater should now function normally.
If the heater’s red indicator light remains illuminated even after positioning the heater back in upright position after being tipped over, the heater may have overheated and will need to be reset as directed above.
TROUBLESHOOTING
PROBLEM: POSSIBLE CAUSE
Unit fails to power on. | Unit is not plugged in. Plug power cord into electrical outlet. Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS. Unit has overheated. Automatic Safety Shut-Off has initiated. See RESET HEATER. Tip-over switch on bottom of unit has been tripped and safety shut-off system has cut power to heater. Place heater on level surface. See SAFETY FEATURES. | |
Unit is not producing sufficient amount of heat. | Ensure unit is set to High Heat. Close all doors and windows to trap heat. Allow unit to fully circulate heat throughout room; may take several minutes. | |
Unit is powered on but there is no heat. | Turn Power Off and unplug unit. A cylindrical plunger is on bottom of unit. Push in 4-5 times, ensuring it is not stuck. Set unit down on flat surface. Ensure power cord is not under unit. |
WARRANTY
Vornado Air LLC (“Vornado”) warrants to the original consumer or purchaser this Vornado® Small Room Tower Heater (“Product”) is free from defects in material or workmanship for a period of five (5) years from the date of purchase. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost