Table of contents
show
KLIPSCH Surround 3 Wireless Speakers User Manual
Contents
- Wireless Speaker
- DC Power Cord
- Transmitter
- Rubber Feet
IMPORTANT SAFETY INSTRUCTIONS!
- DO NOT use this apparatus near water.
- CLEAN ONLY with dry cloth.
- DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two
blades with one wider than the other. - PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus
- The mains plug/appliance coupler is used as disconnect device, the disconnect device shall remain readily operable.
- DO NOT overload wall outlets or extension cords beyond their rated capacity as this can cause electric shock or fire.
SETUP
CONFIGURATION
SURROUND BUTTON
SURROUND PAIRING
- Hold 3 Seconds
BACK PANEL
VOLUME
- Hold 3 Seconds
- Orange LED
- Left Surround
- Press Once
- Red LED
- Right Surround
- Hold 3 Seconds
TROUBLESHOOTING
I Don’t Hear Sound from my Surround Speakers
- Verify that the left and right surrounds speakers are plugged in to a power source.
- Check that the Surround 3 transmitter is inserted into the soundbar.
- Check the LED light on the back of each speaker.
- If it is solid, turn up the Surround Volume using the Surround Speaker Level Adjust procedure.
- Remove end cap
- Press the Surround Pair button for 3 seconds on both speakers
- Press the Pair button on the back of the surround speaker that is flashing for 3 seconds until it glows solid.