CALCINI SweatPro 3 True Wireless Earbuds User Manual

CALCINI SweatPro 3 True Wireless Earbuds User Manual

FIND YOUR FIT
Choose your comfortable size

PAIRING

1. Open the lip of the charging case first (Blue flash and enter the pairing mode)
   
2. Turn on the pairing function via BT on your device
   
3. From the list of available devices select “Calcini SweatPro 3”

Music

Play/Pause

Double-click the left or right earbud

Dial via voice assistant

Long pressing left or right earbud for 4s can activate Siri or other voice assistant Double-clicking the left or right earbud can cancel the call.

Answer/End calls

Game Mode

WaterProof (IPX8)
The earbuds will NOT RECEIVE the BT signal in the following situations: 1.Diving with earbuds 2.Earbuds are submerged in water while swimming (You can take shower with earbuds)

Reset the earbuds

You need to reset your earbuds in the following cases:

1. Bad signal, slow connection
2. Your earbuds are connected to another device

Starting with the earbuds

1. Take both earbuds out of the case
2. Touch and hold on the touch-control panels on both earbuds for 6s to power off until red flashing
3. Touch and hold on to the touch-control panels on both earbuds for 10s. (Bule flashing indicates it is powered on and red flashing 3 times indicates it has been reset successfully)
4. Put both earbuds into the charging case and close the lid
5. Open the lid again, and both earbuds will turn on then enter the pairing mode. Please refer the pages 3-5)

Package Contents

• A Pairs of Earbuds with charging case
• USB-C Cable
• S/M/L Ear Tips
• S/M/L Ear Wings
• User Manual
• Thank Card

Product Diagram

Getting Started

Charging
Fully charge the charging case before the first use. To charge, connect the charging case to a USB charger or charging port with the included USB-C cable.

Controls & LED Indicators
Streaming Audio Once paired, you can wirelessly stream audio on your device via earbuds. Music will automatically get paused when you receive an incoming phone call and will be resumed once the call ends

Specifications

Regular Use After Pairing
Once the earbuds are successfully paired with your device, they can be switched on and off as follows:

1. Open the lid of the charging case, then both earbuds will turn on and connect automatically
2. To turn off, put the earbuds back in the charging case and close the lid. They will begin charging.

Product Care & Use

1. Keep away from liquids and extreme heat
2. Don’t use the earbuds at high volume for extended periods, as this may cause permanent hearing damage or loss.

FCC Warning Statement:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy.

If not installed and used by the instruction may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, this can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following.

REFERENCE LINK