Teeho TE001 Keyless Entry Door Lock User Manual

Teeho TE001 Keyless Entry Door Lock User Manual

Parts illustration

The default master code is 12345678. It’s required that you change it to a code of your own before programming.

How to use it?
Unlock the door from outside

Unlock the door from inside

Lock the door from the outside
Auto re-lock mode
In auto re-lock mode, the bolt will extend out automatically in 30 seconds after unlocking.

Manual mode
Press any of the buttons on the keypad for 2 seconds.

Lock the door from inside
Auto re-lock mode
In auto re-lock mode, the bolt will extend out automatically in 30 seconds after unlocking.

Manual mode
Rotate the turn piece to the lock position.

Quick set up

The default master code is 12345678. It’s required that you change it to a code of your own before programming.

Information and safety warnings

• Protect your user codes and master code.
• Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered without your knowledge.
• This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure a long-lasting finish. When cleaning is required use a soft and damp cloth. Using lacquer thinner, caustic soaps, abrasive cleaners, or polishes could damage the coating and result in tarnishing.

1. Master PIN Code (4~10 digits): The default master PIN code is “12345678”, It’s required that you change it to a code of your own before programming.
2. User PIN Code (4~10 digits): A total of 20 user codes(and one temporary one-time user code) may be programmed.
3. Both master and user PIN codes don’t support the following combination of numbers.

Definitions

1. Master Code
   • Required for programming and feature settings. Master code can be used to unlock the door under vacation mode. The default master code needs to be changed before programming.
   • The property owner/manager should keep this information confidential.
2. Auto Lock 
   • Automatically locks the deadbolt 30 seconds after unlocking. This feature is off by default. You can set the Auto-Lock time delay between 10 and 99 seconds.
3. Wrong Entry Limit
   • After 10 unsuccessful attempts at entering an invalid PIN code, the unit will shut down for 3 minutes.
4. Silent Mode
   • The beep sounds when pressing the keypad can be muted. But you will still hear low battery and system alerts.
5. Vacation Mode
   • You are leaving your home or we will look at the user ves tint master code entered on the keypad. If the lock is unlocked by thumb turn, the lock will sound an alarm.
6. One-Time User Code
   • This code can only be used once and is automatically deleted when used.
7. Unlock with Fake Code
   • Users can prevent pin code exposure from strangers by entering random digits before or after the pin code.

Factory default settings

Restore factory default settings
This procedure will delete all user codes associated with the lock.

1. Keep the door opening and unlocking;
2. Press and hold the reset button, taking out one battery and then place it back at the same time;
3. Keep holding the reset button for 3 seconds until you hear the sound of “ВЕЕР”

Troubleshooting

Operation

If the lock appears to be damaged or does not operate properly, please contact customer service for further assistance.

REFERENCE LINK

https://www.teeho.com/