Gopro Underwater Housing User Manual
DIVE HOUSING
Designed for deep sea diving and extreme activities.
HOUSING LENS COVER
Protects the housing lens from scratches, dirt, and debris.
STANDARD BACKDOOR + STANDARD BACPAC BACKDOOR
Waterproof backdoors for use with or without a BacPac™ accessory.
SKELETON BACKDOOR + SKELETON BACPAC BACKDOOR
Enable optimal audio capture during low-speed activities, and access to an attached LCD Touch BacPac (sold separately). NOT waterproof.
Opening the Dive Housing
- Grip the housing with your left hand.
- Using your right hand, place your thumb on the left side of the arrow and index finger just below the latch.
- Pinch your fingers together, sliding the arrow to the right.
- Use your fingertips to pull the latch upright and unlock it from the housing
Closing the Dive Housing
- Place your GoPro inside the housing.
- Close the housing backdoor.
- Hook the latch into the groove on the backdoor.
- Press down on the latch until it locks into place.
Important Safety + Handling Information
WARNING:
Failure to properly care for your Dive Housing can result in leaks that may damage or destroy your camera. Your warranty does not cover water damage resulting from user error.
CLEANING THE LENS
Clean the housing lens immediately after it comes into contact with anything that may cause a stain, including ink, makeup, dirt, food or lotion. To clean the lens, gently wipe it with a soft, damp cloth. Do not use window cleaners, household cleaners, solvents, alcohol, ammonia, or anything abrasive to clean the lens.
PREVENTING WATER DAMAGE TO YOUR CAMERA
It’s very important to keep the housing’s rubber seal clean. A single hair or grain of sand can cause the housing to leak and damage your camera. To clean the seal, remove it from the housing, rinse it in freshwater, and shake it dry (drying with a cloth may cause lint to compromise the seal). After using the housing in salt water, always remember to rinse it with fresh water to prevent corrosion.
