Airthereal V2 VACTIDE WET DRY VACUUM CLEANER MANUAL

Airthereal V2 VACTIDE WET DRY VACUUM CLEANER MANUAL

SAFETY INSTRUCTIONS

IMPORTANT SAFEGUARDS:
To avoid the risk of serious injury when using your Wet Dry Vacuum Cleaner, basic safety precautions must be followed, including but not limited to the following.

• This handheld floor washer is a household product. Not recommended to be used in industrial, commercial, or other extremely dirty conditions.
• To avoid the risk of electric shock, do not touch the plug or any live part of the product with wet hands.
• If the adapter or plug is damaged, please stop using it. Please call our professional maintenance personnel to replace it to avoid any harm.
  

  Continued

• Please keep the air tunnel and operation part away from long hair, loose clothes, fingers, and other parts of the body. Do not put the vacuum tube, accessory suction head, or tools to the eyes or ears or put them into the mouth.
• Ensure that the Power Switch is in the OFF position before picking up or carrying the appliance. Do not lay flat or lean on the appliance so as to prevent dirty water from entering the motor.
• Do not charge or store the appliance outdoors or inside the car. Only charge, store, or use the battery in a dry indoor area where the temperature is higher than 39.2°F (4°C) but lower than 104°F (40°C). The charger is for indoor use only.
• When using the machine for the first time or after long-term storage, please fully charge the machine first.
• If the machine is not used for a long time, please ensure that it is charged at least every three months to maintain the battery’s health.
• Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
• Do not expose a battery pack or appliance to fire or excessive temperature.
• This appliance contains battery cells that are non-replaceable.
• Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care. Please use our original adapter to charge the unit. Other types of chargers may cause battery failure or extreme thermal effects.

REASONABLE USE ENVIRONMENT OF PRODUCT

• This product is suitable for hard floors in an indoor environment, including waxed floors, stone floors, rubber floors, marble floors, granite floors, terrazzo floors, solid wood floors, composite floors, bamboo floors, and all kinds of mirror tiles, porcelain tiles, etc.
• To prevent roller brush damage please do not use the machine to clean sharp objects.
• The cleaning effect may be reduced If the product is used on an uneven surface.
• Do not use this product near or on the surface of inflammable or explosive objects.
• Do not use this product near a working fireplace or heater to prevent the risk of deformation of the product shell.
• Do not use this product to vacuum other cleaning fluids, kerosene, gasoline, alcohol, oil paint, perfume, etc., as that may cause short circuits, fire, or explosion.
• Do not use this product to vacuum spilled toner from a laser printer or copying machine as that may cause fire or explosion.
• Please do not use the device on high-temperature substances (cigarette ends, matches or hot ashes, etc.), ultra-fine substances (such as lime, cement, sawdust, gypsum powder, ash, carbon powder, etc.), or large sharp fragments (such as glass), otherwise, the product may be blocked and the motor may burn out.

SPECIFICATIONS

COMPONENTS

Product

Charging Base 

Status Display

Contents Introduction

PRODUCT ASSEMBLY

Insert the handle into the corresponding top position of the main body. There are buckles for positioning. If you hear a clicking sound when the handle snaps into place, the installation is complete.

Handle Disassembly
Use a non-sharp auxiliary tool (such as a bamboo stick) to poke into the small hole shown in the figure to hold the handle removal key, and at the same time pull out the handle vertically upward.

PRODUCT OPERATION

Preparation
Please check whether the appliance has power. If not, please charge it (refer to “Product Charging” for details), and use it after fully charged.

Fill the Clean Water Tank

1. Press the tank button to remove the solution tank.
   
2. Open the cover and add clean water, not exceeding the MAX line. (For deep cleaning, please add 16ml (about two bottle caps) of floor cleaning solution.)
   
3. Put the clean water tank back into the vacuum body until it clicks into place.

Note:
If you need to use a cleaning solution, please use the cleaning liquid that comes with this product or another low-foam detergent to prevent product damage.

Wash the Floor

1. Please tilt the machine before turning it on.
2. The ON/OFF button is on the handle as shown in the picture below. Press the button to turn on the appliance. The default mode is the Auto mode. Press the button again to turn off the appliance.
3. When the machine is running, press the Mode button to switch between Auto/ Max/Suction modes.

Warning

• This product has an Upright Switch function. Please tilt the appliance after turning it on. To avoid water leakage, do not tilt the appliance over 140 degrees.
• Please do not vacuum foam liquid. It is recommended to use Max mode for heavy stains.

Charging:

1. Connect the power adapter to the charging base.
2. Place the washer into the charging base as shown in the picture below.

Warning:

• Only charge the appliance with the adaptor supplied by Airthereal.
• During long periods of not being used, the appliance must be charged once every 3 months for optimal performance. It may take about 4 hours for a full charge.
• Store indoors in a dry place. Do not expose the appliance to sunlight or freezing temperatures. The recommended temperature range is 39.2°F (4°C) – 104°F (40°C).

Self-cleaning

1. Empty the dirty water tank and make sure that the clean water tank has enough water.
2. Start the self-cleaning mode.
   • Press the self-clean button to start the procedure as shown in the right picture.
   • After the self-cleaning function begins, the appliance enters charging status and starts the rolling brush auto air dry mode.

Silent Mode

Press the self-cleaning button for 3 seconds to activate or deactivate the voice prompt function.

Product Routine Cleaning

• For optimal performance and to prevent odors, always clean and dry the dirty water tank, floater, filters, brush roller, and brush roller cover completely after each use.
• After maintenance, place the appliance on the storage tray vertically. Do not expose the appliance to direct sunlight. Store it indoors in a dry place.

ROUTINE CLEANING
Cleaning the vacuum cleaner’s body

1. Turn off the power before cleaning the appliance.
2. Clean the body with a soft cloth which could be dampened with clean water or a Neutral detergent.

Attention: Don’t wet the internal components 

Clean the HEPA Filter
Clean the HEPA filter under running water after each use. Make sure the HEPA dries completely before reassembling.

1. Take out the filter support from the water tank cover.
2. Rinse it with running water
3. Install it back into the water tank after it is completely dry.

Clean the Rolling Brush

Clean and dry the brush roller after every use.

1. Pull up the left handle and remove the rolling brush.
2. Remove any tangled hair or debris on the brush roller using the brush cleaning tool.
3. Rinse the rolling brush under running water.
4. Please wipe any stains on the nozzle with a wet cloth.
5. Assemble the rolling brush back into the appliance.

TROUBLESHOOTING

LIMITED WARRANTY

We provide a 1-year warranty. For more information please visit www.airthereal.com/warranty.

• What’s covered? Defects due to faulty materials and/or workmanship of the product.
• What’s not covered?
  • Damage caused by the owner when attempting to fix or alter the product by himself or herself.
  • Damage caused by misuse, abuse, neglect, alterations, or unauthorized repair.
  • Natural depreciation.
• Warranty Period Warranty becomes effective from the date of original purchase and will last for 1 year.
• Who’s covered? This limited warranty is only effective for the original purchaser, it is non-transferable.
• How to request warranty services? To obtain the benefit of this warranty, please email support@airthereal.com. Our customer service will address your issue as soon as possible!

Always here to help you
www.airthereal.com
Produced for: West Ryder Technology LLC
2330 Paseo Del Prado STE C304 Las Vegas, NV 89102 USA

REFERENCE LINK