RING Video Doorbell 3 Plus User Manual
Charge the provided battery.
Plug the battery in.
First, fully charge the battery by plugging it into a power source using the provided orange cable. The small light on top will glow green once fully charged.
Insert the battery.
After charging, insert the battery in the bottom of your Video Doorbell until it clicks into place.
Set up your Video Doorbell in the Ring app.
Download the Ring app
The Ring app walks you through setting up and managing your Video Doorbell. Search for “Ring” in one of the app stores below, or visit: ring.com/app
Set up your Video Doorbell near your Wi-Fi router
In the Ring app, select Set Up a Device. When prompted, select Doorbells, and follow the in-app instructions.
Try it out!
After setup, push the button on the front of your Video Doorbell to see video from the camera in the Ring app.
Install your Video Doorbell.
Select your install height.
Install a Video Doorbell approximately four feet (1.20 meters) above the ground for optimal performance. If you’re connecting to existing doorbell wiring that’s higher than four feet, thus limiting where you can install your new Doorbell, use the provided wedge mount to angle your Doorbell down.
Remove your existing doorbell. (optional)
If replacing an existing doorbell, shut off power at the breaker. Then remove it from the wall and disconnect the wires. Your Video Doorbell is compatible with doorbell systems supplying 8-24 volts AC at 50 or 60Hz, 40VA max. Do not wire your Video Doorbell to a DC-powered intercom system or other DC power source.
Do you have an in-home chime?
If desired, the chime can ring when the button on your Ring Doorbell is pressed. Just follow the in-app instructions during setup.
Install the anchors. (optional)
If installing on stucco, brick, or concrete, mark 4 drill holes. Use the provided masonry drill bit to drill holes in your wall, then insert the included anchors.
Connect the wires. (optional)
Connect the wires coming out of your wall to the screws on the back of your Video Doorbell. Either wire can connect to either screw. The order doesn’t matter.
Attach the wire extensions. (optional)
If you have trouble connecting the wires coming out of your wall to the back of your Video Doorbell, use the provided wire extensions and wire nuts.
Screw it in.
Feed all the wires (and the wire nuts, if you used them) into your wall and secure your Video Doorbell on the wall using four screws.
Install the faceplate.
Place one of the provided faceplates on your Video Doorbell by slotting it in at the top and clicking it into place.
Secure the faceplate.
Lastly, insert one of the provided security screws into the bottom, and tighten with the star-shaped end of the screwdriver bit. That’s it! Your Video Doorbell is now ready to use.
Customer Support
Hereby, Bot Home Automation, declares that this consumer electronic complies with the essential requirements and other relevant provisions of Directive 1999/5/ EC. The declaration of conformity may be consulted at www.ring.com/DoC.pdf.
Protect the device from direct sunlight. Install the device at dry locations and protect it against rain and humidity. The device may not come into contact with salt water or other conductive liquids. The device must be charged only within a building in a dry state.
REFERENCE LINK
https://support.ring.com/hc/en-us/articles/360038220912-Ring-Video-Doorbell-3-Plus-Information
