Ring Video Doorbell Setup User Manual
Diagram
Set up your Ring Contact Sensor
Set up your Ring Contact Sensor near your Base Station:
To add devices to your Ring Alarm, it must be disarmed. If your Ring Alarm is armed, please disarm it now. In the Ring app, choose Set Up a Device and find Ring Contact Sensor in the Security Devices menu. To complete the setup process, follow the in-app instructions.
Connect your Ring Contact Sensor to your Base Station
When prompted, scan the QR Code or enter the PIN:
The QR Code and PIN can be found on the back of your device, on the box, or on the card in this box
Pull the tab on the Contact Sensor:
This connects the battery and turns on the Sensor. Your Base Station finds it automatically.
Track the connection progress of the Sensor:
Your Sensor will try to connect to your Base Station. The Sensor’s LED ring lets you track the progress
Open and close the sensor to test it:
Make sure the app shows that the sensor is open when you pull it apart.
Install your Ring Contact Sensor on the wall
Place your Sensor (but don’t install it yet):
Hold the Sensor where you want to install it. Place it near an edge of the door or window that will move.
Align the magnet and the sensor:
Place the magnet on the trim near the sensor so that the lines on the sensor and magnet are parallel. The magnet and
sensor can be a maximum of 1/2” apart.
Install your Sensor on a door or window:
Use the bracket and tape or screws included in your kit.
How to change the battery
Press the clip and remove the sensor cover. Replace the battery with a fresh CR123A cell.
