Xfinity Voice Remote Control Setup User Manual
Meet Your Remote
Turn On Your Remote
Your remote arrives with the AA batteries already installed, but not activated. Here is how to power it on for the first time.
- Pick up your remote and remove the “Pull” tab (on back) by pulling away from the remote. The Status LED will blink green four times as the remote powers up (about 5 seconds).
Turn on your TV.- Turn on your set-top box.
Turn on your TV.
Pair Remote and Xfinity Voice Remote Control Setup User Manual
Control your set-top box without having to point your remote at the device, even when it is located inside a cabinet or entertainment center.
- Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
Press the XFINITY button.- Follow the on-screen instructions to enter the 3-digit code that appears.
Press the XFINITY button.Control Your TV’s Power
- Using the list on the right, find the first 5- digit code for your TV manufacturer.
- Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
Enter the first 5-digit code for your TV manufacturer. The Status LED should flash green twice.
Enter the first 5-digit code for your TV manufacturer. The Status LED should flash green twice.
- Verify that the code was accepted by using your remote to adjust volume and turn the TV on and off.
Test Voice Control
Once your remote is paired with your set-top box, you can use voice control.
- Press and hold the Voice button until you hear the audio tone.
Speak a voice command to the remote while continuing to hold down the button. Try one of the suggestions below. The Status LED will be solid blue while you speak your command.- Release the Voice button when your command is complete. Look at the TV for the results of your voice command.
Speak a voice command to the remote while continuing to hold down the button. Try one of the suggestions below. The Status LED will be solid blue while you speak your command.FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications.
- Reorient or relocate the receiving antenna.
- Increase or decrease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
- Consult the dealer or an experienced remote control /TV technician for help.
- It is strongly recommended that the TV be plugged into a separate wall outlet.
