Table of contents
show
SoundPeats Watch Pro 1 Smart Watch with Heart Rate User Manual
Product introduction
Wearing
Wear the wristband about one finger away from the wrist bone and adjust the tightness of the wristband to a comfortable position.
Tip: If you wear the strap too loose, the data acquisition of heart rate sensor may be affected.
Connection and binding
- Scan the QR code on the watch display (Settings-APP Download) by your mobile phone, and then install the APP SOUNDPEATS SPORTS. You can also scan the QR code below to download and install SOUNDPEATS SPORTS from the mobile APP store.
- After installing the APP, open and log in SOUNDPEATS SPORTS, then select (device WATCH Pro1 to be added) on the device page so as to connect it.
Operation
- Open the control panel: Swipe the screen on the main interface downwards from the top
- Open the messages/notifications: Swipe the screen on the main interface upwards from the bottom
- Open the main menu: Swipe the screen on the main interface from left to right (Note: On other interfaces, slide your finger from left to right to return to the previous interface)
- Open the status interface: Swipe the screen on the main interface from right to left
- Quick dial change: Press and hold the dial interface for 3 seconds, and the watch vibrates once; then you can slide your finger to left or right to select the dial.
- Power on: Press and hold the Power button for 5 seconds to switch it on (Power off: You need to press and hold the button for 3 seconds when the display is on to select whether to power off)
- Quick sports pause/continue: Press the power button.
- Press the power button to return to the homepage (Note: If you are on the level 2 interface, you will return to the level 1 interface).
Features
Charging
- Place the watch on the magnetic charging cable and make sure the charging contacts on the back of the watch are fully attached to the metal contacts of the charging cable. It can be fully charged within about 3.5 hours.
- Plug the charging cable into a standard USB charger purchased via official channels. The output voltage is 5V and the output current is 1A.
If the watch can’t be turned on after being left for a long time, please wipe the charging contacts of the charging cable when using it again to remove the sweat or moisture residue.
Note: (If you do not use the watch often, please charge it once every month.)
Basic parameters
Warranty regulations
When purchasing products from the original buyer, we begin to guarantee watches for a period of 12 months, and the warranty scope is limited to manufacturing defects.
support@soundpeatsaudio.com
www.soundpeatsaudio.com
DOWNLOAD PDF LINK
