Wyndham Collection WC-5151-30-SGL Single Vanity Guide
- Prior to installation please check received items against the “Packing List”. Please report any missing items to your retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
- Professional installation is recommended.
PACKING LIST
INSTALLATION INSTRUCTIONS
CABINET ALIGNMENT GUIDE
ALL cabinets are aligned, and the metal trim is adjusted on a level floor before packaging. After shipping and reaching its destination, the cabinet doors and drawers may require minor alignment, depending on the condition of the floor where they will be installed. DO NOT move/adjust the door hinges or drawer glides before leveling/adjusting the cabinet on the floor.
Start by adjusting the back two feet #3 and #4 by bringing the cabinet to a level position. Use a spirit level to ensure accuracy. After adjusting all four feet (front and back) check the metal trim alignment. After leveling the metal trim lines make sure all 4 vanity feet are firmly resting on the floor and the cabinet is perfectly level.
The backboard is pre-cut for ease of installation for hot and cold valves and drains.
Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over-apply. Allow to dry for 24 hours for proper curing.
Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over-tighten when reattaching.
Plug in an electrical outlet and USB charging hub.
HOW TO ADJUST DRAWER SLIDES (if required)
Backboard Cutouts
Electrical Outlets with Charging Hub
- Easy to install
- Long 5-foot plug-in cord
- 2 electrical outlets, 125V 15A
- Tamper Resistant (TR) outlets
- Power reset switch
- 2 USB ports, 5V 2.1A Max
- Use with ground-fault circuit interrupter (GFCI) outlets only
- Residential use only
- Follow all applicable electrical codes
- ETL Listed
- Conforms to UL Standard 962A
- Certified to CAN/CSA Standard C22.2 No. 308
