Table of contents
show
SWANN Wireless Motion Sensor Spotlight User Manual
PRODUCT OVERVIEW
Spotlight
Remote Control
BATTERY INSTALLATION
Spotlight
The spotlight requires four size D 1.5V batteries (not included). For reliable, long-lasting performance, use only high quality alkaline or lithium batteries. To install batteries:
- Turn the front cover of the spotlight counter-clockwise to the unlock position , as shown below, to release and remove the cover.
- Insert batteries according to the polarity markings (+ and -) indicated inside the battery compartment.
- Align the marks then turn the front cover clockwise to the lock position , as shown below, to secure the battery compartment.
Remote Control
The remote control is powered by one CR2025 3V battery which comes pre-installed.
- To activate the battery, simply pull the plastic film out from the bottom of the remote control.
- To replace the battery, push the tab on the left of the battery tray towards the right and pull out the battery tray from the remote, as shown in the diagram on the back of the remote. Place one new “CR2025” battery on the tray with the positive (+) side facing up. Insert the tray back into the remote.
USING THE REMOTE CONTROL
- When aiming the remote control towards the spotlight, ensure that the distance is within 12m/40ft and there is no obstruction between the remote control and the spotlight.
- When you press a button on the remote control, the spotlight will flash the red Enforcer LED light once to confirm it has received the command.
- If you set both “Light on Motion” and “Enforcer on Motion” to OFF, the spotlight will power off for 1 hour. After 1 hour, the spotlight will automatically switch back to “Light on Motion” mode.
- To operate only Enforcer Lights on motion, perform these steps in the following order:
- Press the “Light on Motion” ON button.
- Press the “Enforcer on Motion” ON button.
- Press the “Light on Motion” OFF button.
MOUNTING THE SPOTLIGHT
- Remove the mounting base from the stem by turning the thumb screw A counter-clockwise.
- Attach the mounting base to the mounting surface using the supplied screws (if mounting on drywall/masonry, install wall anchors first).
- Insert the stem back into the mounting base and turn the thumbscrew A clockwise until it is secured tightly.
- To adjust the angle of the spotlight, loosen the knuckle screw B . Aim the spotlight in the desired direction then tighten the knuckle screw B to hold it in place.
