Table of contents
show
Meletrix Zoompad Ultimate Numpad User Manual
PACKAGE CONTENT
INSTALLATION STEPS
- Please make sure to check if the brown or black packaging box is undamaged. Please check if the items listed above are not missing. If you’re missing any of the items above please contact the store you purchased it from before proceeding ahead.
- To test the function of the PCB first: remove the top case of the kit, plug the daughter board cable into the PCB.Then use the coiled cable to connect the computer and the daughter board.
- First use the tweezers to test the socket, then test again whether the encoder is normal (turn left and right and press down) the corresponding key will light up on the via to indicate that it can work normally. (if there is something wrong, please contact the store you purchased it.)
- Test the bluetooth function: take out the battery, connect the PCB interface, plug the socket into NUM and 1, press NUM first,then press 1,long press for a few seconds, the green indicator light flashes, unplug the data cable, under wireless mode any key can be triggered means the bluetooth function is normal.(if there is something wrong, please contact the store you purchased it.)
- Test the 2.4G function: plug the socket into NUM and 4, press Fn then 4, the purple indicator will flash quickly. After the 2.4G USB receiver is successfully connected to the computer, the purple light will flash once. Press any key to trigger it without plugging the data cable to indicate that the connection is successful.
- Next, to lubricate the stabilizer: take out the stabilizer, apply grease on both sides of the stabilizer stem and on two ends of the steel wire. Then put the steel wire into the stabilizer stem and press it down from bottom to top.
- Install the stabilizer:take out the PCB and the lower socket pad, place the frosted surface of the lower socket pad on the PCB, then use the socket body to fix the lower socket pad,pay attention to the hole position(stabilizer hook feet to the big hole), and finally install the screw rubber feet and tighten the screws.
- Put the poron plate foam on the PCB( pay attention to distinguish the front and back), take out the PC plate to install the gasket sleeve, then install the PC plate copper column and place it on the PCB, finally screw the standoff screws.
- Finally, let’s install poron PCB foam so the inner liner is ready! Then take out the external weight and install it on the bottom case and screw it. Then put the battery on and plug it into the PCB battery port.
- After adjusting the inner liner, put on the case, quickly lock the upper and lower case fixing screws, and finally install the rubber feet after the case being screwed.
- Install all the sockets.
- Install all the keycaps.
- Take out our matching lighting knob, find the right position and use the matching small screwdriver to tighten the fixing screw. Gently pulling and not fall means that the instal- lation is correct (the following picture is only for demonstration).
- Finally, let us show you some shortcut keys: NUM+Del is the shortcut of the RGB switch, NUM+Pause is to switch the light effect, NUM+ “+” is to reduce the brightness while NUM+” ” is to increase the light.
- This building guide is over till now, wait to see you next time!
REFRENCE LINK
