NUWAVE ON THE GO BLENDER OWNER MANUAL
PARTS & ACCESSORIES
INSTRUCTIONS
Before Use: Check to see that all the accessories are included and not damaged.Wash the accessories prior to use. Wipe down the Power Base with a wet towel. Never pour water directly over the Power Base or wash it in
the dishwasher.The blender comes partially charged. Fully charge the blender using the USB-C cable. You can connect the cable to any mobile phone power bank or mobile power bank as long the other end has a USB-A input.
The blender will light up red while it charges, it will turn blue once it is fully charged. The normal charge time is 4 to 5 hours. Operations After being fully charged, the blender will operate for up to 30 minutes or approximately 60 cycles before it needs to be charged again.
Notes
- 1 cycle is 30 seconds with 2 minutes of wait time before the next cycle.
- When the Jar is not attached, the blender flashes red-blue-red-blue.
Blending
- Be sure the Jar is properly attached to the Power Base.
- Before blending, cut all solid foods into small chunks.
- First, add your liquid(s) to the Jar.
- Add your solids and/or ice.
- Once all ingredients have been added, secure the Strainer on the Jar, then the Lid.
- Press the Power button twice to begin blending.
Note
Blending with the Strainer is optional. Use the Strainer if you wish to filter out chucky pieces.
Tip: If the blades become jammed, turn off the blender. Turn the blender horizontally and gently shake. If the blades are still jammed, turn the blender upside down and gently shake.
Hot Liquids
Do not add liquids over 120˚F/49˚C as this can damage the blender and cause leaks.
Note
- ALWAYS make sure all parts are attached and secure.
- Do not overload the blender with ingredients. ALWAYS leave room at the top.
- Do not run the blender with an empty Jar. This could burn out the motor.
Safety Features The blender is equipped with a safety sensor that prevents the blades from spinning when the jar is detached.
TROUBLESHOOTING GUIDE
The Jar is screwed into the Power Base, but machine does not work. Make sure the cup is screwed on tightly enough.
The red light stays on during mixing. Insufficient voltage. Fully charge the Power Base before use.
The red light flashes when the power is turned on, and the blades do not turn.
- The battery temperature in the Power Base is too hot. Power off the unit and let it cool before use.
Note
The above are common troubleshooting methods. For more information and assistance contact Customer Service at 1-877-689-2838 or email help@nuwavenow.com.
CLEANING & MAINTENANCE
Fast Cleaning
Add warm soapy water to the Jar, press the Power button two times and rinse.
Note For deep cleaning, remove the Lid and Strainer, as well as the attached silicone rings. Wash them with warm, soapy water using a brush, sponge or wet towel. Allow to dry. Do not pour water onto the Power Base. Use a wet towel to clean.
Specifications
Model No: 28401
Voltage: DC7.4V
Power: 70W
USB Cable: Type-C
Charging Time: 4 – 5 hours
LIMITED WARRANTY
The NuWave On-The-Go Blender
THE MANUFACTURER WARRANTS
The On-The-Go Blender and all electrical components, are to be free from manufacturer defects.All electrical components are warrantied for 3 months from the date of purchase, under normal household use, and when operated in accordance with the Manufacturer’s written instructions. The Manufacturer will provide the necessary parts and labor to repair any part of the On-The-Go Blender at NuWave LLC Service Department. After the expiration of the warranty,the cost of the labor and parts will be the responsibility of the owner.
THE WARRANTY DOES NOT COVER
This Limited Warranty does not cover failure, damages or inadequate performance due to accident, acts of God (such as lightning),fluctuations in electric power, alterations, abuse, misuse, misapplications,corrosive-type atmospheres, improper installation, failure to operate in accordance with the Manufacturer’s written instructions, abnormal use or commercial use. NuWave LLC reserves the right to void the Limited Warranty, where allowable by law, for products purchased from an unauthorized dealer.
TO OBTAIN SERVICE
The owner shall have the obligation and responsibility to: pay for all services and parts not covered by the warranty; prepay the freight to and from Service Department for any part or system returned under this warranty; and carefully package the product using adequate padding material to prevent damage in transit. The original container is ideal for this purpose. Include in the package the owner’s name, address, daytime telephone number, a detailed description of the problem, and your “RGA number.” (Call 1-877-689-2838) or email help@nuwavenow.com to obtain the RGA number (Return Goods Authorization number). Provide the cooking system model & serial number and proof of date of purchase (a copy of the receipt) when making claims under this warranty.
MANUFACTURER’S OBLIGATION
The Manufacturer’s obligation under this Limited Warranty is limited, to the extent allowable by law, to repairing or replacing any part covered by this Limited Warranty which upon examination is found to be defective under normal use. The Limited Warranty is applicable only within the continental United States and only to the original purchaser of the manufacturer’s authorized channels of distribution. THE LIMITED WARRANTY MAY NOT BE ALTERED, VARIED OR EXTENDED EXCEPT BY A WRITTEN INSTRUMENT EXECUTED BY THE MANUFACTURER. THE REMEDY OF REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS LIMITED WARRANTY IS EXCLUSIVE. IN NO EVENT SHALL THE MANUFACTURER BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES TO ANY PERSON, WHETHER OR NOT OCCASIONED BY NEGLIGENCE OF THE MANUFACTURER, INCLUDING WITHOUT LIMITATION, DAMAGES FOR LOSS OF USE, COSTS OF SUBSTITUTION, PROPERTY DAMAGE, OR OTHER MONEY LOSS.
