Table of contents
show
Amazon Basics BOBH4LN6XG Lint Remover Fabric Shaver Guide
Product Description
- A. Protective cover
- B. Blade guard with 4-hole sizes
- C. Blade attachment
- D. Safety latch
- E. Blade bin
- F. 1/0 (On/off) switch
- G. Battery compartment
- H. Rear cover
- I. Container
- J. Replacement blade attachments (×2)
- K. Cleaning brush
Before First Use
A DANGER
Risk of suffocation! Keep any packaging materials away from children and pets – these materials are a potential source of danger, e.g. suffocation.
- Remove all the packing materials.
- Remove and review all components before use.
- Check the product for transport damages.
Operation
Inserting batteries
NOTICE
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
- Lift and remove the rear cover (H) (Fig. 1).
- Insert 2x AA 1.5 V batteries into the battery compartment (G) (Fig. 2).
- Refit the rear cover (HI/Fig 7)
Switching on/off
- To switch the product on, slide the l/O switch (F) forward (Fig. 4).
- To switch the product off, slide the 1/O switch (F) backward (Fig. 4).
Use
- Place the piece of fabric/garment on a flat and even surface.
- Switch the product on, and then select a small inconspicuous area to test before moving on to a larger area.
- Using a light amount of pressure, slowly glide the blade guard (B) against the fabric in a forward, backward, and side-to-side motion (Fig 5) (Fig 6).
- Switch the product off and rearrange the fabric to start the process again
NOTICE
- Do not use the product on embroideries, zips, buttons, and loose threads.
- The product does not switch on if the blade guard (B) is not fully installed and the safety latch (D) is not fully pressed.
Cleaning and changing the blade attachment
- To clean the exterior, wipe with a soft, slightly damp cloth.
- Wipe the product dry after cleaning.
- Never use corrosive detergents, wire brushes, abrasive scourers, or metal or sharp utensils to clean the product.
- To clean all other parts of the product, complete the following steps:
- Remove the protective cover (A) (Fig. 7).
- Remove the blade guards (B) by turning it counter-clockwise (Fig. 8)
- Clean the underside of the blade guard (B) with the cleaning brush (K) (Fig. 9).
- Carefully lift out the blade attachment (C) from the blade bin (E) making sure to only hold the sides of the attachment (Fig. 10).
- Clean the blade attachment (C) and the blade bin (E) with the cleaning brush (K) (Fig. 11).
- Refit all the parts after cleaning is complete.
REFERENCE LINK
DOWNLOAD PDF LINK
