Viewsonic CDE3203 32″ Full HD LED-Backlit Commercial Display User Guide
Getting started
Connect to your Computer
HDMI
- Step 1: Identify the connector on your PC.
- Step 2: Connect video signal with appropriate connector cable
DVII
- Step 1: Identify the connector on your PC.
- Step 2: Connect video signal with appropriate connector cable.
- Step 3: Connect audio signal with appropriate connector cable.
D-SUB
- Step 1: Identify the connector on your PC.
- Step 2: Connect video signal with appropriate connector cable.
- Step 3: Connect audio signal with appropriate connector cable.
LCD Display
- Step 1: Register online at: http://www.ViewSonic.com/support
- Step 2: Check your accessory contents in packaging.
- Step 3: Install 2 AAA batteries (included in package) in your remote control.
- Step 4: Install your LCD display. If you want to hang the LCD display on the wall, please refer the User Guide for detailed instructions.
Enjoy FHD Experience:
Set up your ViewSonic LCD display by using proper connections to an HD content source such as your HD cable or satellite box.
Connect your LCD display
Power off your LCD display until you complete all the connections
Connect your PC to your ViewSonic LCD Display
- For the D-Sub connection, you need to apply D-Sub cable and mini 3.5mm audio cable.
- For the DVI connection, you must apply DVI or DVI-to-HDMI cable and additional audio cable.
- Change the PC setting to display on LCD display.
- For detailed information, please refer to your User Manual.
- Please contact ViewSonic Service Team if you had any problem on connection.
Initial Setup
Step 1: Power on the display
- Plug the power cord
- Press POWER to turn on the display
Step 2: Language setting
- Press to enter OSD
- Press ◄/►, then OK to select Setup menu
- Enter Language and choose the desired one
Step 3: Select video source
- Press INPUT to display the Source Select menu. Press ▲/▼ to select the correct input source and press OK to confirm the selection.
Step 4: Adjust the volume.
- Change the volume Using + VOL – on the remote control or display
- Mute the current sound output
- Press MUTE to turn off the sound. To restore the sound, press this button again, or press the VOL +/- button.
Watching Your LCD display
Adjust Display Mode:
Your ViewSonic LCD display supports several aspect ratios. For best viewing, select the appropriate Zoom Mode to suit the viewing display. The 16:9 aspect ratio looks perfect on your ViewSonic LCD display. For different aspect ratio, press on your remote control and select Picture > Zoom Mode to change.
Customize:
Picture Mode ViewSonic LCD display includes several preset view options optimized for different viewing conditions. Press P.MODE on your remote control, or press on your remote control and select PICTURE > Picture Mode. Choose the appropriate mode to suit your content.
Programming your Cable or Satellite Box remote
Refer to the user manual from your service provider to determine the setting.
Using USB Flash Drive
- Plug the USB device into the USB jack.
- Press INPUT to select USB.
- Select Music, Photo, Movie or Text.
- Choose the file to playback.
FCC Compliance Statement
This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
REFERENCE LINK
https://www.viewsonic.com/eu/products/sheet/CDE3203
https://www.viewsonic.com/
