Conair TS184GS Travel Smart Instruction Guide

Conair TS184GS Travel Smart Instruction Guide

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following:

READ ALL INSTRUCTIONS BEFORE OPERATING APPLIANCE

DANGER

Any appliance is electrically live even when the switch is off. To reduce the risk of death by electric shock:

• Always unplug appliance immediately after using.
• Do not place or store appliance where it can fall or be pulled into a tub or sink.
• Do not place in, or drop into water or other liquid.
• If an appliance falls into water, unplug it immediately. Do not reach into the water

WARNING

To reduce the risk of burns, electrocution, fire, or injury to persons:

• This appliance should never be left unattended when plugged in.
• Close supervision is necessary when this appliance is used by, on, or near children or the physically challenged. Unsupervised use could result in fire or personal injury.
• Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
• Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged, or dropped into water. Do not attempt to repair the appliance. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used. Return the appliance to an authorized service center for examination and repair.
• Keep the cord away from heated surfaces. Do not allow cord to contact heated surfaces. Do not pull or twist cord. Let appliance cool completely before putting away. Loop cord loosely around appliance when storing.
• This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• Never drop or insert any object into any opening.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
• Do not use an extension cord to operate appliance.
• Surfaces of this appliance may be hot when in use. Do not let heated surfaces touch eyes or bare skin.
• Do not place the steam nozzle directly on any surface or on the appliance power cord while it is hot or plugged in.
• Unplug this appliance before filling or emptying. Do not overfill.
• While emitting steam, this appliance may cause burns if it is used too close to the skin, scalp or eyes, or if it is used incorrectly. To reduce the risk of contact with hot water coming from steam vents, test appliance before each use by holding it away from body.
• Do not operate steamer without properly filling the water container.
• Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
• Burns could occur from touching hot parts hot water, or steam. Use care when you turn a steam appliance upside down – there may be hot water in reservoir.
• To reduce likelihood of circuit overload, do not operate another high wattage appliance on the same circuit.
• When installing or removing attachment, please be sure the unit is off and no steam is being released to avoid contact with hot water.
• Use caution when installing or removing attachment as it may contain hot water from condensation. Ensure the attachment is dry or cooled off to avoid contact with hot water.

DUAL VOLTAGE

This is a 120/240V dual voltage appliance and may be used in the United States and abroad without an electricity converter.

• An adapter plug may be necessary when using this appliance in some foreign countries.
• If so, plug the steamer into correct adapter plug for your location and plug assembly into electrical outlet.

NOTE: This unit is thermostatically protected to shut off when water has boiled away. You should unplug the unit before this occurs because surfaces continue to heat, which could be hazardous and may damage unit. Before using the garment steamer for the first time, it is recommended to operate the steamer for approximately 5 minutes, unplug the unit and allow it to cool. Empty container and refill before actually using.

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

HOW TO USE

• Be sure garment steamer is unplugged.
• Release handle by pushing red button.
• While holding main body of steamer, twist steamer head counterclockwise and lift it to remove.
• Fill reservoir with ordinary tap water to max fill line. DO NOT OVERFILL.
• Replace steamer head on steamer body, twisting clockwise into locked position.
• If steam is spitting or dripping, this indicates that there may be too much water in the unit. For the best performance, we strongly recommend filling the reservoir with less water.
• Attach brush accessory to steamer if desired. (Please refer to brush attachment section)
• Place appliance on a flat surface in an upright position. Plug into electrical outlet.
• Within a few minutes, the unit will begin to emit a continuous flow of steam from the steam vents. The garment steamer is now ready to use.
• Hold steamer by its handle when using. Do not grasp body of unit while steaming garments or while unit is hot.
• Direct the flow of steam toward garment to remove wrinkles. Do not touch fabric with steam head. Steamer can be used in either a horizontal or vertical position. However, do not tilt steamer upward as hot water may leak.

BRUSH ATTACHMENT

Your garment steamer includes a brush attachment for extra grooming and care of all your clothes. The brush helps the steam penetrate the fabric by separating the fibers. You can use the steamer to effectively remove wrinkles with or without using the brush attachment. Do not attempt to attach or remove the brush attachment while unit is steaming or hot. Wait until unit is completely cool. Place the brush onto the steamer head by simply pushing the brush onto the front of the steamer head. The wider portion of the brush attachment should be toward the bottom of the unit.

TO STEAM GARMENTS OR DRAPES

• Hang up garment/drapery.
• Gently hold fabric taut with one hand and hold steamer with the other hand. Hold steamer near the garment/drapery so that steam is directed toward it. Use only in vertical position.
• Slowly run the steam head up and down and side to side. To remove stubborn wrinkles,

move the garment steamer very slowly.

TO MAKE CREASES OR PLEATS

• Hang garment.
• Fold fabric where crease or pleat is desired. Hold fold in place while applying steam directly to fold.

TO STEAM TIES

• Hang tie on hanger.
• Apply steam directly to tie.

TO STEAM SHOULDERS AND SLEEVES

• Hang garment, preferably on a padded hanger.
• Fill out shoulders or sleeves with folded towel.
• Apply steam to garment.

LIMITED ONE-YEAR WARRANTY

Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $5.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.

DOWNLOAD PDF LINK

TS184X

https://www.conair.com/en/pro-garment-steamer/TS184X.html?lang=en_US