Forever CS-100 Folding Electric Scooter User Manual

Forever CS-100 Folding Electric Scooter User Manual

SAFETY INSTRUCTIONS

1. Before using for the first time, read this manual and keep it for future reference.
2.  Always follow local regulations when operating an electric scooter.
3.  Only one person can use this scooter.
4. Keep your feet on the scooter while riding.
5. Aerobatics or jumps are not recommended. These actions may increase the risk of injury or damage to the scooter / user.
6. Use extreme caution when driving with poor visibility, bad weather or in the evenings.
7.  The first ride should be on a flat surface without any obstacles.
8.  Wear protective clothing including a helmet and shoes.
9.  Be careful when riding the scooter in difficult or uneven terrain. Do not expose yourself or others to dangerous situations.
10. Check all consumables regularly. In the event of any backlash, remove them immediately.

IMAGE DESCRIPTION

1. Handles
2. Front light
3. Folding hook
4. Buckle
5. Buckle Lock
6. Folding handle
7. Foot brake
8. Motor
9. Charging port
10.  Leg
11. Deck
12.  Grip throttle
13.  Electric brake
14.  LCD Display

UNFOLDING AND FOLDING THE SCOOTER

SCOOTER UNFOLDING

1. Place the electric scooter on its wheels
2. Right hand presses down the rear fender and left hand pulls up the long pole until folding hook gets out of the hook.
3. Set the steering wheel to the maximum vertical position, then snap the buckle.

SCOOTER FOLDING

1.  Right index finger lift the buckle lock up. Push the folding wrench outward with the thumb to put down the upright pole
2. Snap the handle into the clip.

HANDLES ASSEMBLE

• Install the Handles and tighten the handles

SCOOTER CHARGING

1.  Make sure the charging socket is clean and dry
2. Connect the charging cable to the charging adapter
3.  Connect the power adapter to a 100-240 V AC power outlet
4.  Connect the output cable from the charger to the scooter charging socket, the LED on the power supply will light up red
5. When the LED turns green, charging has finished
6. Disconnect the charger

NOTES ABOUT CHARGING

• If the green light on the charger does not turn RED after connecting your scooter, check that the cables are properly connected; or the scooter is already fully charged. Press and hold the power button to check the battery status on the display.
• Do not overcharge, as this will affect the battery life.
• The best charging temperatures are between 0 ° and 40 °. Extreme cold and extreme heat will prevent the battery from fully charging.
• Remember to disconnect the charger from the power supply before using the scooter.
• Only use the scooter charger included in the kit.
•  If the scooter is turned on after inserting the plug, the battery indicator will start flash

ELECTRIC SCOOTER RIDING

• TURNING ON THE SCOOTER:
  Press and hold the ON / OFF button for about 3 seconds
• PREPARATION FOR DRIVING:
  Lay one foot on the scooter’s ground, push the other leg away from the ground moving for about 5 km / h while pushing the throttle grip. When the engine starts, put the other leg on the scooter board.

• STOPPING THE SCOOTER:
  To brake safely, release the throttle grip then depress the braking grip . The second way is to use the foot brake
• TURNING OFF THE SCOOTER:
  Press and hold the ON / OFF button for about 3 seconds

DISPLAY DESCRIPTION

MAINTENANCE

Storage and cleaning
If the electric scooter gets dirty, clean it with a damp cloth (before using the cloth, you can pre-remove dirt with a stiff brush). If the removal of dirt is difficult, you can also use a small amount of cleaning paste. Then clean the scooter with a damp cloth. Make sure that the electric scooter is switched off during cleaning and cover the charging socket to avoid problems with electronics.

Handling the battery
Protect batteries from temperatures above 50 ° C or lower than 10 ° C for a long time. Low temperatures can damage the battery cells. Keep the electric scooter away from open flames or other heat sources to prevent the battery from heating up. The scooter should also not be left at temperatures below freezing. Both hot and excessive cold can discharge the battery. Do not discharge the batteries completely. It is recommended to charge the batteries before fully discharging. This will increase battery performance. Also, riding the scooter in cold and very hot places can shorten the battery life compared to driving at 15 ° -25 ° Celsius.

Bearing maintenance
The electric scooter has sealed and dust-free bearings, so oiling is not necessary. To avoid danger when driving, regularly check the bearings for wear. Do not jump or apply excessive pressure to avoid damage to the bearings. This is not a sports scooter.

 Maintenance of screws and other fasteners
Make sure that all screws are properly tightened to avoid a hazardous situation. Remember to lubricate moving parts regularly. To ensure the best ride possible.

SPECIFICATION

• Power : 100-240V ~/ 50-60Hz
• Battery capacity: 36V, 5000 Ah
• Battery type : Li-Ion
• Maximum distance on one charge: 10-15 km (depending on the user’s weight, weather conditions, surface and slope)
• Charging time: 3h
• Max speed: 25 km/h
• Load capacity: 120 kg
• Maximum climbing angle: 10°
• Front light: Yes, LED
• Dimensions ( folded ):1065 x 430 x 480 mm
• Dimensions ( unfolded ) : 1065 x 430 x 1180 mm
• Foldable: yes
• Speed levels: 3
• Brakes : electric – motor and foot (fender)
• On-board computer: Yes
• Weight: 11,9 kg

REFERENCE LINK

https://manual.forever.eu/file/1583242289.pdf