Table of contents
show
EVERBILT DPPR100 Pressure Regulator User Manual
INSTALLATION
- Remove the elbow insert from the pump body.
Connect the plug to the elbow insert hole.
Thread the pressure regulator into discharge outlet. Screw the 1/4 in. brass elbow into the 1/4 in. hole on the
side of the pressure regulator. Slide the plastic tubing over the 1/4 in. brass elbow connected with the pressure
switch connector.
Turn the regulator adjustment screw down tight.- Turn on the pump. If the pump is properly primed, a high pressure will immediately show on the pressure gauge.
- With the pump operating at high pressure, slowly unscrew the adjusting screw until maximum water flow is obtained without pressure dropping to zero.
- If pressure falls completely, retighten the screw and readjust it.
- If no pressure shows, stop the pump, remove the pressure regulator from pump, add more water, and try again.
- After the adjusted bolt is set up, lock the screw nut on the bolt.
- The pump is ready for use.
Connect the plug to the elbow insert hole.
Thread the pressure regulator into discharge outlet. Screw the 1/4 in. brass elbow into the 1/4 in. hole on the
Turn the regulator adjustment screw down tight.
