Table of contents
show
Homedics Illuminated Tabletop Relaxation Fountain User Manual
IMPORTANT SAFETY INSTRUCTIONS
DANGER
TO REDUCE THE RISK OF ELECTRIC SHOCK:
- Always unplug the appliance from the electrical outlet immediately after using it and before cleaning.
- DO NOT reach for an appliance that has fallen into the water. Unplug it immediately.
- NEVER use pins or other metallic fasteners with this appliance.
WARNING
- An appliance should never be left unattended when plugged in. Unplug from the outlet when not in use, and before putting on or taking off parts or attachments.
- Close supervision is necessary when this appliance is used by, on, or near children, invalids, or disabled persons.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by HoMedics; specifically, any attachments not provided with the unit.
- NEVER operate this appliance if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a HoMedics Service Center for examination and repair.
- Keep the cord away from heated surfaces.
- NEVER drop or insert any object into any opening.
- DO NOT operate where aerosol (spray) products are being used or where oxygen is being administered.
SAVE THESE INSTRUCTIONS
CAUTION
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.
- NOT recommended for use by diabetics.
- NEVER leave the unit unattended, especially if children are present.
- NEVER cover the unit when it is in operation.
- DO NOT use this product for more than 15 minutes at a time.
- Extensive use could lead to the product’s excessive heating and shorter life. Should this occur, discontinue use and allow the unit to cool before operating.
- NEVER use this product directly on swollen or inflamed areas or skin eruptions.
- DO NOT use this product as a substitute for medical attention.
- DO NOT use this product before bed. The massager has a stimulating effect and can delay sleep.
- NEVER use this product while in bed.
- This product should NEVER be used by any individual suffering from any physical ailment that would limit the user’s capacity to operate the controls.
Assembly and Instructions for Use
- Unpack the product. Wipe off the dust with a damp cloth.
- Familiarize yourself with the pump. The pump speed is controlled by the switch located at the front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed, move the switch slowly downward in the direction of the plus sign. You will hear a click as the switch moves to each speed level. At its highest speed level, the switch will cease to move any further. To decrease the pump speed, move the switch upward toward the minus sign. Similarly, at its lowest speed, the switch will cease to move any further (Fig 1). NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.
- Insert the rubber end of the waterproof light into the light clip located inside the base. (Fig.2) Slight twisting may help to push the rubber end through the clip more easily. Note: Be gentle with the bulb cover since it is made of glass.
- Lead the power cord up through the cord slot located on the back wall of the base. (Fig. 3)
- Insert the plastic tube attached to the fountain top through the tube slot located on the back wall of the base. (Fig. 4)
Cotinued
- Be sure the fountain top is sitting level on the base and then secure it down using screws. (Fig. 4) Note: You will need a Phillips screwdriver to assemble. (Not Included)
- Insert the black connector at the bottom of the plastic tube into the round opening of the pump. (Fig. 5)
- Plug the cord into a 120V household outlet. The fountain is controlled by a switch located on the power cord. If the pump does not operate, rotate the in-line switch once to turn “on” and once to turn “off”. Note: Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent water from running down the electrical cord into the electrical outlet. (Fig. 9)
Maintenance
- To clean the pump: Unplug from the electrical outlet. Remove it from the base of the fountain. Use a small brush or stream of water to remove any debris (Fig 10).
- To keep the water clean: Periodically change the water and clean the product according to the water condition. Keeping the water clean prevents the water from becoming sticky and forming micro-organisms. We recommend distilled water to prevent mineral buildup.
- To clean off hard water deposits on the base: Soak the container in a mixture of vinegar and water to clean and remove any mineral build-up.
- Keeping the water at an optimum level: Add water periodically to keep the water level at an optimum level to avoid shortening the life of the pump. NOTE: Never let the pump run dry, as this will shorten the life of the pump.
- Fountain Storage Unplug the fountain from the electrical outlet, empty the water and store the fountain in a dry, cool place.
Changing Light Bulb
First, unplug the fountain and let the bulb cool down. Remove the bulb cover by holding the glass bulb cover in a dry hand and rubber neck with the other hand. Slowly pull apart. Slight twisting may help to loosen. Be gentle with the bulb cover since it is glass. Never pull on the cord. Next, pull the bulb straight out and replace it with a new bulb, inserting prongs into the holes. Replace the bulb cover securely.
Troubleshooting
- If the pump fails to operate, check the following: Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical power. NOTE: Always disconnect from the electrical outlet before handling the pump.
- If the pump gurgles, spews, or “burps”: Check the water level to make sure the pump has enough water to function.
- Obtaining a desired water level: Check the water level daily during the first week to measure the rate of evaporation; refill with water as needed.
- If water is splashing outside the fountain: Adjust the flow control valve to a lower setting on the pump
DOWNLOAD PDF
REFERENCE LINK
Homedics Illuminated Tabletop Relaxation Fountain User Manual_
