Table of contents
show
Kbice FDFM1JA01 Self Dispensing Nugget Manual
SAFETY INSTRUCTIONS
- This appliance is equipped with a 3-prong grounding-type plug.
- It is required to use a 3–prong grounding type electrical outlet properly grounded in accordance with the National Electrical Code and local codes and ordinances.
- A separate adequately fused and grounded circuit shall be used for this appliance. The voltage rating must match the rating label on the unit.
- Do not under any circumstances cut or remove the third ground prong from the power cord.
- Never unplug the appliance by pulling the power cord. To disconnect the unit always grip the plug firmly and pull it straight out from the wall outlet.
- Do not operate the appliance if the appliance housing is removed or damaged.
- Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this manual. All other servicing shall be referred to a qualified technician.
- To protect against electric shock do not immerse the appliance plug or cord in water or other liquids.
Cleaning
- Unplug the appliance before performing any maintenance.
- Do not clean appliances with flammable fluids. Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other unit. The fumes can create a fire hazard or explosion.
- Do not use solvent-based cleaning agents or abrasives on the interior or exterior of the appliance. These cleaners may damage or discolor the appliance.
- Do not operate the appliance with wet hands, while standing on a wet surface, or while standing in water.
FEATURES & SPECIFICATIONS
Overview
This compact automatic ice dispenser allows you to enjoy nugget ice with the touch of a button. Water fill through the push-to-open or removable door makes it portable and easy to use.
Features and Parts
- Display Panel
- Ice Dispense Point
- Water Port for Funnel
- Reservoir Cover
- Air Vent
- Water Drip Tray
- Power Cord
- Drain Tube Plugs/Holder
Note
- This compact automatic ice dispenser allows you to enjoy nugget ice with the touch of a button.
- The built-in ice engine can quickly make nugget ice within 60 minutes and produce 22 lbs of ice per day.
- Automatic cleaning and descaling programs keep the unit clean and in top operational condition.
- Water fill through a push-to-open or removable cover provides you with the convenience to use it anywhere.
- Less than 17.5 inches in height allows for installations on any counters and tables.
Specifications
How to descale the unit with citric acid once a month to prevent sediment from building up
- Unplug the unit
- Empty the ice bin and water reservoir following the instructions in Section 2.
- To make a descaling solution, mix 15 teaspoons of food-grade citric acid powder with 100 fl oz potable water.
- Fill the water reservoir with the descaling solution to MAX WATER FILL.
- Plug the unit into power.
- Press and hold the Clean button for 3 seconds to start Cleaning mode for the descaling process.
- Unplug the unit and drain the water following instructions in Section 1 when the descaling process is complete (the Cleaning LED goes off).
- Plug the unit into power.
- Fill the water reservoir with clean potable water again.
- Press and hold the Clean button for 3 seconds to start Cleaning mode for the rinse process.
- Press and hold the Clean button again for 3 seconds in 5 minutes to stop rinsing.
- Drain water following instructions in Section 1.
- • Repeat the rinse process 3 times until the water is clean and tastes good.
How to sanitize the unit with chlorine bleach once a month to prevent bacteria from growing
- Empty the ice bin and water reservoir following the instructions in Section 2.
- To make sanitizing solution, mix 1 teaspoon of 5% food-grade chlorine bleach with 100 fl oz clean potable water.
- Fill the water reservoir with the sanitizing solution to MAX WATER FILL.
- Plug the unit into power.
- Press and hold the Clean button for 3 seconds to start Cleaning mode for the sanitizing process.
- Unplug the unit and then drain the water following instructions in Section 1 when the sanitizing process is complete (the Cleaning LED goes off).
- Plug the unit into power.
- Fill the water reservoir with clean potable water again.
- Press and hold the Clean button for 3 seconds to start Cleaning mode for the rinse process.
- Press and hold the Clean button again for 3 seconds in 5 minutes to stop rinsing.
- Drain water following instructions in Section 1.
- Repeat the rinse process 3 times until the water is clean and tastes good.
You may hear the following normal operating sounds
- You may hear a boiling, rattling, or gurgling sound produced by the flow of refrigerant through the evaporator.
- You may hear air being forced through the condenser by the condenser fan.
- You may hear a clicking sound produced by the refrigerant valve or water valve.
- You may hear a high-pitched hum or pulsating sound produced by the compressor.
- You may hear a high-pitched sound produced by the gear motor.
- You may hear ice being ejected from the ice engine to the ice bin.
INSTALLATION INSTRUCTIONS
Location
- Place the unit away from direct sunlight and heat sources.
- Do not install the unit in moist areas.
- Do not install the unit in the garage.
- Do not install the unit where the ambient temperature range will be below 50 °F or above 80 °F. Otherwise, the unit will not be able to work properly.
- The unit must be placed in a properly ventilated location to prevent heat build-up generated by the refrigeration system. Failure to do so will prevent the unit from cooling properly and may result in damage to unit components as well as its contents.
- The unit must be installed on a counter that is level and strong enough to support up to 50 lb.
Clearance
- Do not block the air vent on the left side.
- Allow for a minimum of 12 inches of clearance on the left side.
- Allow for a minimum of 1/2 inch of clearance on the right side.
- Allow for a minimum of 2 inches of clearance on the back.
- Allow for a minimum of 1/2 inch of clearance on the top.
Electrical Requirements
- A dedicated 120V, 60Hz, 15A fused, grounded electrical supply is required. We recommended a separate circuit serving only your appliance.
- We do not recommend using outlets that can be turned off by a switch.
- Only plug the unit into a grounded 3-prong outlet.