KLIPSCH Surround 3 Wireless Speakers User Manual

KLIPSCH Surround 3 Wireless Speakers User Manual

Contents

1. Wireless Speaker
2. DC Power Cord
3. Transmitter
4. Rubber Feet

IMPORTANT SAFETY INSTRUCTIONS!

1. DO NOT use this apparatus near water.
2. CLEAN ONLY with dry cloth.
3.  DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.
4. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
5.  DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two
   blades with one wider than the other.
6. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus
7. The mains plug/appliance coupler is used as disconnect device, the disconnect device shall remain readily operable.
8.  DO NOT overload wall outlets or extension cords beyond their rated capacity as this can cause electric shock or fire.

SETUP

CONFIGURATION

SURROUND BUTTON

SURROUND PAIRING

• Hold 3 Seconds

BACK PANEL

VOLUME

1. Hold 3 Seconds
2. Orange LED
3. Left Surround
4. Press Once

1. Red LED
2. Right Surround
3. Hold 3 Seconds

TROUBLESHOOTING

I Don’t Hear Sound from my Surround Speakers

1. Verify that the left and right surrounds speakers are plugged in to a power source.
2. Check that the Surround 3 transmitter is inserted into the soundbar.
3.  Check the LED light on the back of each speaker.

•  If it is solid, turn up the Surround Volume using the Surround Speaker Level Adjust procedure.
•  Remove end cap
•  Press the Surround Pair button for 3 seconds on both speakers
• Press the Pair button on the back of the surround speaker that is flashing for 3 seconds until it glows solid.

REFERENCE LINK

https://www.klipsch.com/