Victor M250S Electronic Mouse Trap User Manual

Table of contents show

Victor M250S Electronic Mouse Trap User Manual prduct img

Victor M250S Electronic Mouse Trap User Manual fig 1

Turn the switch to the “OFF” position and insert 4 AA batteries into the battery compartment.
Open the kill chamber door and bait trap with peanut butter in the indicated bait cup.
Turn the switch to the “ON” position. The green light will flash and the unit will buzz to indicate the unit has been enabled. Once a rodent is caught, a green light will flash for up to one week.
Place the trap along a wall, making sure the side with the rodent entrance is against the wall.

A red light indicates low battery life. Replace batteries.

TO DISPOSE OF RODENT
Turn the switch to “OFF”. Open the kill chamber door and properly discard rodents.

Victor M250S Electronic Mouse Trap User Manual fig 2

Disassembly: Turn the switch to “OFF”. Hold the trap with the battery compartment in your left hand, the power switch facing upwards, and the rodent entrance facing towards you.
With your right hand push forward and separate the kill chamber from the electronics housing.
The kill chamber is now ready for cleaning. Open rodent disposal door. Use a soft bristle brush and warm soapy water to scrub inside of the chamber if desired.
Thoroughly dry the interior and exterior of the kill chamber prior to trapping reassembly.
Assembly: Hold the battery compartment in your left hand with the power switch facing upwards and align key holes. Insert keys into opposite openings and pull the right hand backward to reconnect halves
The trap is ready for use.

DOWNLOAD LINK

Victor M250S Electronic Mouse Trap User Manual