MAKITA AN611 Construction Coil Nailer Gun User Manual

MAKITA AN611 Construction Coil Nailer Gun User Manual

Safety Instructions

For personal safety and proper operation and maintenance of the tool, read this instruction manual before using the tool.

General safety

•  Do not permit those uninstructed to use the tool.
•  No horseplay. Respect the tool as a working implement.
•  Do not operate when under the influence of alcohol, drugs or the like.
• Never alter the tool.

Personal protective equipment

•  Always wear safety glasses to protect your eyes from dust or fastener injury.

WARNING: It is an employer’s responsibility to enforce the use of safety eye protection equipment by the tool operators and by other persons in the immediate working area.

Work area safety

•  Keep work area clean and well lit. Cluttered or dark areas invite accidents.
•  Do not operate the tool in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Operating the tool can create sparks which may ignite the dust or fumes.
•  Keep children and bystanders away while operating the tool. Distractions can cause you to lose control.
• Illuminate the work area sufficiently.
• There may be local regulations concerning noise which must be complied with by keeping noise levels within prescribed limits. In certain cases, shutters should be used to contain noise.

INSTALLATION

Selecting compressor

Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 50 times per minute at a compression of 0.59 Mpa (5.9 bar), a compressor
with an air output over 80 liters/ minute is required. Pressure regulators

Selecting air hose

• Use an air hose as large and as short as possible to assure continuous, efficient nailing operation. With an air pressure of 0.49 Mpa (4.9 bar), an air hose with an internal diameter of over 6.5 mm and a length of less than 20 m (6.6 ft.) is recommended.

Lubrication

•  To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool. Adjust the oiler so that one drop of oil will be provided for every 30 nails
• When an air set is not used, oil the tool with pneumatic tool oil by placing 2 (two) or 3 (three) drops into the air fitting

FUNCTIONAL DESCRIPTION

Adjusting depth of nailing

• Always lock the trigger and disconnect the hose before adjusting the depth of nailing.
•  To adjust the depth of nailing, turn the adjuster so that the arrow above the adjuster will point to the number indicated on the adjuster

1.  Adjuster

• Lift and turn the coil support plate to set it to the correct step. When loading 57 or 65 mm long nails, use the bottom step

• Place the nail coil over the coil support plate. Uncoil enough nails to reach the feed claw

MAINTENANCE

• Always disconnect the air hose from the tool before attempting to perform inspection or maintenance.
•  Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.

Maintenance of nailer
Always check the tool for its overall condition and loose screws before operation. Tighten as required. Make sure all safety systems are in working order before operation. Test for possible faulty operation with nails unloaded

1. Change lever
2. Trigger lock

Maintenance of compressor, air set and air hose
After operation, always drain the compressor tank and the air filter.

1.  Drain cock

SPECIFICATIONS

REFERENCE LINK

https://www.makitatools.com/