Monster CW3-22003 SM1 Bluetooth Sunglasses User Manual
OVERVIEW
PRODUCT SPECIFICATIONS
| Model | CW3-22003 |
| Bluetooth Version | V5.1 |
| Bluetooth Protocol | A2DP/AVCTP/AVDTP/AVRCP/HFP/SPP |
| Frequency level | 2.402GHz – 2.480GHz |
| Distance | 10M |
| Music playing time | 6-7h |
| Phone call time | 7h |
| Charging volt | 5V |
| Charging time | 2h |
| Standby time | 200h |
| Battery | 450833 3.7V 100mAh*2 |
| Weight | 38.5g |
| Shell material | PC+TR90 |
| Lens material | PC |
| Charging port | Magnetic suction |
OPERATIONAL INSTRUCTION
Power On:
- Touch to start (wear detection)
- Automatically enter Bluetooth pairing mode after power-on.
Power Off:
- No touch, let the glasses stand for 15 seconds to shut down.
- Power off automatically after charging.
Function key on the left
- Touch and tap 2 times: answer the call/end the call
- Touch and click 2 times: next song
- Touch and click 1: Play/pause
- Touch and hold for 2s: voice assistant
- Touch and click 3 times: volume is reduced.
key on the right
- Touch and tap 2 times: answer the call/end the call
- Touch and click 2 times: previous song
- Touch and click 1: Play/pause
- Touch and hold for 2s: reject the call
- Touch and click 3 times: volume increases
Function key on both sides
- Long press for 5S on both sides at the same time: force into the pairing, and give priority to the left and right mirror legs to form a team
- Press and hold for 8S on both sides to clear the Bluetooth address or restore factory Settings.
Indicator light
- Switch on the blue indicator for 1S
- Pairing mode The red and blue lights blink alternately
- Charge the red light, full bright blue light
- Low power indicator: < 20%. The red light blinks
- Clear the Bluetooth address blinking red at short intervals
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0cm between the radiator and your body.
