Eufy P940 Pet Water Fountain User Manual
IMPORTANT SAFETY INFORMATION
- Replace the filter every 2-4 weeks.
- When the device is not in use, the power should be turned off.
- Turn off the power before cleaning the base. Ensure that it is fully dry before use.
- Make sure the water level in the tank is between the “MIN” and “MAX” water lines, which are marked inside the water tank.
- The water tank is detachable. DO NOT lift the device by the water tank when moving.
- Only the stainless drinking tray can be washed by a dishwasher.
- Wash away the activated carbon powder on the filter before use.
AT A GLANCE
- Spout
- Drinking Tray
- Filter The filter removes fur, metal ions, and odors.
- Filter Tray
- Water Outlet
- Water Pipe
- Water Tank
- LED Indicator
Steady Red:
No water left → Refill water Flashing Red:- No rotator in the device → Put in a rotator
- Water tank displacement → Put it in place
- Pump damage → Contact eufy Support Team
- Base
GETTING STARTED
- Put the rotator in the hole.
- Align the rear end of the water pipe with the rotator and press down until it locks in place tightly.
- Connect the two parts of the water pipe tightly
- Add water to the max level.
- Attach the filter tray to the tank, and put the filter on the filter tray. Wash the filter before using it.
- Attach the drinking tray to the filter tray.
- Insert the spout into the head of the water pipe.
- Plug in the base to power your Pet Water Fountain P940.
Note:
- After being powered on, Pet Water Fountain P940 will continuously dispense water.
- If no water is left in the tank, the device will stop working automatically. To resume normal operation, refill the water first. Then unplug and plug the charging cable, or lift up and put down the water tank.
MAINTENANCE
Excess impurities on the filter, water pipe, and rotator will reduce water quality and lower water flow. We recommend cleaning these parts each time you clean the device and replacing the filter every 2-4 weeks.
Note:
- Be careful not to lose the rotator while cleaning the device.
- Do not clean the base with water. Use a dry cloth instead.
- The rotator may stop working due to slight shaking, but it can automatically resume working after a while.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type T8790 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://uk.eufylife.com/. The adapter shall be installed near the equipment and shall be easily accessible. Do not use the Device in the environment at too high or too low temperature, never expose the Device to strong sunshine or a too wet environment. The suitable temperature for the product and accessories is -20°C to 60°C. When charging, please place the device in an environment that has normal room temperature and good ventilation. It is recommended to charge the device in an environment with a temperature that ranges from 5°C~25°C.
CUSTOMER SERVICE
Warranty
12-month limited warranty
Call Us
United States
+1 (800) 988 7973 Mon-Fri 9 AM-5 PM (PT)
United Kingdom
+44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT)
Germany
+49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
Email Us
Customer Support: support@eufylife.com
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
REFERENCE LINK
https://us.eufy.com/products/t7320121
