Panasonic ER224 Wired Headphones User Manual

Panasonic ER224 Wired Headphones

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using this appliance.

DANGER

To reduce the risk of electric shock:

1. Do not reach for an appliance that has fallen into water. Unplug immediately.
2. Charger unit is not for immersion or for use in shower.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
4. Except when charging, always unplug this appliance from the electrical outlet immediately after using.
5. Unplug this appliance before cleaning.
6. Do not use an extension cord with this appliance.

WARNING

To reduce the risk of burns, fire, electric shock, or injury to persons:

1. Close supervision is necessary when this appliance is used by, on, or near children or invalids.
2. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
3. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
4. Never drop or insert any object into any opening.
5. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
6. Do not use this appliance with a damaged or broken comb, as facial injury may occur.
7. Plug charger directly into receptacle – do not use an extension cord.
8. Unplug charger before plugging or unplugging appliance.

SAVE THESE INSTRUCTIONS

Important

Cautions for charging:

•  Dry the trimmer completely before charging it.
•  Do not charge the trimmer at temperatures below 0 ˚C (32 ˚F) or above 40 ˚C (104 ˚F), or where it will be exposed to direct     sunlight or other heat sources.
•  Do not continue charging for more than 48 hours as it may damage the battery.
•  The trimmer may become warm during operation and charging. This is normal.
•  The adaptor is intended to be correctly oriented in a vertical or floor mount position.

Cautions for adaptor:

• Use only the included adaptor RE9-32.
• Keep the adaptor away from water and handle it only with dry hands.
• Store the adaptor in a dry area where it is protected from damage.

Cautions for use and storage:
The following is the symbol of Wet trimmer. The symbol means that the hand-held part may be used in a bath or shower.

•  Turn off the trimmer before changing the trimming length or removing the comb attachment.
•  Keep out of reach of children.
•  Do not tamper with the moving parts.
•  Do not use on animals.
•  Do not disassemble the trimmer.
•  Do not store the trimmer in a place exposed to direct sunlight or near a heater or other source of heat.

Cautions for cleaning:

• Do not take the housing apart as this can affect the watertight construction of the trimmer.
• Wash the trimmer in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for     toilets, bathrooms or kitchen appliances. Do not submerge the trimmer in tap water for a long time.
•  Clean the housing only with a soft cloth slightly dampened with tap water or soapy tap water. Do not use a caustic cleaner such
  as benzine or bleach.

Specifications

• Power source:  120 V AC, 50 – 60 Hz
• Motor voltage:  1.2 V DC
• Charging time: This product is intended for household use only.

Parts identification

•  Switch: Slide up to turn on, slide down to turn off.
•  Charge Indicator Lamp: Lights when the unit is connected with the adaptor M to an AC power source for charging.
•  Main Blade: A precision 39 mm-wide blade which can be used with the comb attachment F.
•  Quick Adjust Dial: Turn the dial to a higher setting to raise or lower the comb attachment F to the desired length (between 1 and 20 mm) (see fig. 2). The comb attachment is locked in position when the switch is set to “1”.

Trimming Length Indicator

The actual hair length may be longer than the set trimming hight.

•  Comb Attachment for Hair Use this to control the trimming length. (see fig. 3)
•  Moving Blade
•  Stationary Blade
•  Cleaning Lever Push this lever to remove bits of hair caught between the stationary blade and the moving blade.
•  Blade Block Release to remove the blade block from the housing to clean or replace the blade. (see fig. 12)
•  Finishing blade of Mini Trimmer Use this when finishing the edges (see fig. 8) and trimming the moustache.
•  Trimmer guide of Mini Trimmer Slide it up when finishing blade is used.
•  Adaptor Use this to connect the trimmer to an AC power source for recharging.
•  Oil Lubricate the space at 5 spots between the stationary and moving blade with oil after use. (see fig. 16) O Cleaning Brush

READ ALL INSTRUCTIONS BEFORE USE.

Operation

Charging and cordless trimming
When charging the beard/hair trimmer for the first time or when it has not been in use for more than 6 months, charge it for the activation for at least 16 hours before use. Connect the adaptor to the beard/ hair trimmer, and plug the adaptor to an AC outlet. In some areas, a special plug adaptor may be required. The charge indicator lamp lights up when the trimmer is being charged. (see fig. 4) You can fully charge the trimmer in 8 hours if it seems to be losing speed. A full charge will supply enough power for approx. 6 trims (5 minutes per trim for a normal beard).

Trimming of beard
Place the angled face of the comb against the skin and cut the beard by moving the trimmer in all directions to obtain a uniform cut. (see fig. 5) With curly facial hair, the comb attachment may not cut all of the hair. In this case, remove the comb attachment and use a conventional comb to draw out the remaining uncut hair. (see fig. 6) When shaping the beard, remove the comb attachment. Place the angled edge against the skin and make the border of the beard even.

When finishing the edges

(see fig.8) and trimming the moustache (see fig. 9) Use the finishing blade of mini trimmer. Slide the trimmer guide up and then turn the trimmer on (see fig. 7). To smooth off a beard surface, run this blade lightly over the surface.

Cutting of hair
Cut hair to the correct height by moving the trimmer back against the flow of the hair.
Cutting around the ears
Cut a little, and then gently separate the trimmer from the hair (see fig. 10).
Cutting at the nape of the neck
Bring the trimmer gently away from the hair to finish (see fig. 11). (Do not use the trimmer in an inverted position. This can cut hair too deeply.) Turn off the trimmer (“0•charge”) before changing the trim height or removing the attachment.

Blade Maintenance
Hold body of the trimmer with Panasonic mark upwards, place the thumb against the blades, and push them away from the main body. (see fig. 12)

•  If washing in water

1.  Rinse off any hairs that are sticking to the blade in running water.(see fig. 13)
2.  Rinse out any hairs that are inside the trimmer with running water. (see fig. 14)
3.  Shake the trimmer 4-5 times gently, wipe off any water drops from the trimmer and blade, and then place it onto a towel with the Panasonic mark facing downward to let it fully dry. (see fig.15)
4.  Apply 5 drops of the oil to the points indicated by the arrows.(see fig. 16)
5.  Remount the blade on the trimmer body.

WARNING: Detach the trimmer from the adaptor before cleaning it in water.

• • If cleaning with brush

1.  Remove the blade and brush off the cut hairs from the blade edge.
2.  Use the cleaning brush to brush off the cut hairs from the trimmer body and from around the blade. (see fig. 17)
3.  Brush the cut hairs out from between the stationary blade and the moving blade. Press down on the raise the moving blade, and brush the cut hairs out from between the blades. (see fig. 18)
4.  Apply a few drops of the oil to the points indicated by the arrows. (see fig. 16)
5.  Remount the blade on the trimmer body.

Blade life
Blade life will vary according to the frequency and length of use. For example, using the unit for 10 minutes every 3 days, the life expectancy is approximately 3 years. If cutting efficiency is reduced substantially despite proper maintenance, the blades have exceeded their service life and should be changed. The replacement part no. is WER9602.
Battery life
Battery life will vary according to the frequency and length of use. If the battery is charged 3 times a month, the service life will be approximately 6 years. If the unit is left without being charged for more than 6 months, the charge will drain from the battery and their service life may be shortened. Therefore, even when not using regularly, it is recommended that the unit be recharged at least once every 6 months.

ATTENTION:
A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle this battery.

How to remove the built-in rechargeable battery before disposal of the trimmer.

The battery in this trimmer is not incenter. The procedure described below is intended only for removal of the rechargeable battery for the purpose of proper disposal. Always make sure that the battery have been removed from the trimmer before disposing of it.

1.  Disconnect the adaptor from the AC outlet, and remove the adaptor from the trimmer.
2.  Remove the blade from the trimmer. Remove the screw (a) and detach the bottom cover (b). (see fig. 19)
3.  Detach the dial cover (c), remove the screw (d) and disconnect the dial (e).
4.  Remove the two screws (f).
5.  Detach the housing (g), front panel (h) and side panel (i), then remove the trimmer drive rod (j) (see fig. 20).
6.  Remove the two screws (k)
7.  Remove the two screws (l) and disconnect the rubber push plate (m). (see fig. 21)
8.  Remove the screws (n) and disconnect housing (o).
9.  Disconnect the battery chamber (p) and remove the battery (q). (see fig. 22)

CONTACT INFORMATION

IN USA CONTACT:
Panasonic Consumer Electronics Company One Panasonic Way 2F-3 Secaucus, NJ 07094

IN PUERTO RICO CONTACT:
Panasonic Puerto Rico, Inc. San Gabriel Industrial Park 65th Infantry Avenue KM9.5 Carolina, Puerto Rico 00630
IN CANADA CONTACT:
AU CANADA, CONTACTER:

• Panasonic Canada Inc.
• 5770 Ambler Drive, Mississauga, Ontario L4W 2T3 (905) 624-5010
• Vancouver: (604) 278-4211
• Calgary: (403) 295-3955
• Toronto: (905) 624-8447
• Montréal: (514) 633-8684
• En México:
• Panasonic de México, S.A de C.V.
• México D.F.
• Moras 313 Col. Tlacoquemecatl Del Valle Del.
• Benito Juarez Mexico, D.F. 03200 Mexico
• Tel: 54 88 10 00
• Service • Assistance •Accessories
• Dépannage • Assistance • Accessoires
• Call 1-800-338-0552 (In USA)
• panasonic.com/shavers (In USA)
• Call 1-800-467-3405 (In Canada, only for shavers)
• Composer 1-800-467-3405 (Au Canada, pour les rasoirs seulement)

Download Pdf Link

https://help.na.panasonic.com/wp-content/uploads/2023/02/ER224_ENG_FRE_ESP.pdf