Rode Wireless Go Compact Wireless Microphone System Manual
OVERVIEW
The Wireless Go is a compact wireless microphone system that operates in the 2.4GHz spectrum. The kit includes a transmitter with an internal microphone and a receiver with a 3.5mm TRS output.
SET UP
Press and hold the power button for 3 seconds to turn on the RX (receiver). Press and hold the power button for 3 seconds to turn on the TX (transmitter). The units will already be paired and start transmitting audio, the transmitter will be using the internal microphone. Clip on the supplied windshield if required If desired, plug in a compatible external microphone and the TX will automatically switch the audio input. Connect the 3.5mm TRS output of the RX to a camera’s microphone input or similar audio device.
TRANSMITTER – TX
Power Button
Press and hold the power button for 3 seconds to turn on the unit Press and hold the power button for 3 seconds to turn off the unit Single press to turn it on when the device is in charging mode
Internal Microphone
The transmitter will use the internal microphone if there is not an external microphone plugged in Onboard processing is optimized for the human voice.
Microphone Input
Standard 3.5mm TRS microphone input Supplies 2.8V plug-in power for compatible microphones “Power” and “Link” LED’s Power LED Solid = internal battery is above 20% Slow fl ash = internal battery is below 20% Rapid fl ash = internal battery is below 10% Double fl ash = Charging through USB (solid when 100% charge is reached)
Link LED
Solid = Paired and transmitting to an RX Slow fl ash = Not connected to the RX or out of range Rapid fl ash = in pairing mode (will time out after 3 seconds) Off = TX is in charging mode and not transmitting to a receiver.
RECEIVER – RX
Power Button
Press and hold the power button for 3 seconds to turn on the unit Press and hold the power button for 3 seconds to turn off the unit Single press to turn it on when the device is in charging mode
“dB” Button
Press the “dB” button to cycle through the three audio output levels (0dB, -12dB, -24dB) Set the level according to the requirements of the device receiving the audio. I.e. portable recorder, smartphone, camera, etc. The RX will remember the selection chosen for future use.
Link Button
The RX and TX will come pre-paired out of the box If pairing is required Press and hold the button for 3 seconds The signal strength icon on the screen will start fl ashing Single press the power button on the TX The TX and RX should pair immediately.
Audio output
- Standard 3.5mm TRS output
- Multi-mono signal
USB-C
Standardized USB-C port Used for charging with USB power supplies and is able to connect to a computer for future firmware updates The screen will display charging mode if the unit is plugged into power while off, a quick single press of the power button will turn on the RX.
REFERENCE LINK
https://rode.com/en-us/microphones/wireless/wirelessgo
DOWNLOAD PDF LINK
