Rowenta IS5100 GARMENT STEAMER User Manual

Rowenta IS5100 GARMENT STEAMER User Manual

DESCRIPTION

1. Steam head
   a. On/off and Steam Set button
2. Hook
3. Flexible fabric hose
4. Pole locking ring
5. Removable water tank
6. Telescopic pole
7. Rotating change
8. Dual clip system for pants
   a. Higher part to hang
   b. Lower part to tighten
9. Fabric brush
10. 10. Power indicator light
11. Clips for pole fastening
12. Power cord clips

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using the iron. When using your iron, basic safety precautions should always be followed, including the following:

1. Use iron only for its intended use.
2. To protect against the risk of electric shock, do not immerse the iron in water or other liquids.
3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect the iron.
4. Do not allow the cord to touch hot surfaces. Let the iron cool completely before putting away. Loop cord loosely around iron when storing.
5. Always disconnect the iron from the electrical outlet when filling with water or emptying and when not in use.
   

   Continued

6. Do not operate the iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Contact our Consumer Service Department for examination, repair, or adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not leave the iron unattended while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down – there may be hot water in the reservoir.
9. This appliance is only for domestic and personal use.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 15 amp. cord should be used. Cords rated for less amper may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic Compatibility, Low Voltage, Environnement).

• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children must be supervised to ensure that they do not play with the appliance.
• During the first few uses, a harmless odor and a small amount of smoke may be given off. This has no effect on the use of iron and will disappear quickly.
• Warning! The voltage of your electrical installation must correspond to that of the iron (120V or 127 V). Connecting to the wrong voltage may cause irreversible damage to the iron and will terminate the guarantee.
• If it is absolutely essential to use an extension cable, choose a 15 amp cord.
• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger.
• The appliance should not be used if it has fallen if it has obvious damage if it leaks or functions incorrectly. Never dismantle your appliance: have it inspected by an Approved Service Centre, to avoid any danger.
• Never immerse your iron in the water!
• Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rinsing the water tank, before cleaning it, and after each use.
• Never leave the appliance unattended when it is connected to a power source or if it has not cooled down for approximately 1 hour.
• Your appliance gives off steam, which may cause burns.

GARMENT STEAMER ASSEMBLY

Pole assembly

1. Place the base on the floor and put in the water tank. (fig.1)
2. Insert the telescopic pole into the base and turn the locking ring to secure it into place. (fig 2a, 2b)
3. Fit the hook onto the top of the pole until you hear a click sound. (fig.3)
4. Insert the hanger into the 2 holes located at the back side of the hook and pull it down to secure it. (fig.4a, 4b)
5. Place the steam head on the hook.

Functioning of the rotary hangers
This garment steamer is equipped with rotary hangers in order to store the steamer easily. To turn the hangers

1. Gently pull the hanger (a) to free it from the notch located at the back of the hook (b). (fig.5)
2. Turn the hanger to set it horizontally or to store it vertically. (fig.6 and 7)
3. Fit parts (a) and (b) together in the desired position. (fig.8) The dual clip system is adjustable in height in order to be perfectly adapted to the different garment lengths.

Fabric brush assembly

Be sure unit is unplugged and completely cool before attaching this accessory

• Insert the fabric brush into the holes located on the steam head. (fig.9)
• Before removing the fabric brush, be sure the appliance is unplugged and totally cool.
• Pull the brush out of the steam head to remove it.

TIP
Before using this accessory, check the manufacturer recommendations. It is also recommended that you carry out a test on part of the fabric which cannot be seen.

Filling the water tank 

IMPORTANT
Never use water that contains additives (starch, perfume, aromatic substances, softener, etc) in the steamer. Additives such as these can affect the properties of the steam and lead to the formation of deposits. Never use water complitely distilled or demineralized.

• Ensure that the steamer is unplugged (fig.11). Remove the water tank from the base of the appliance by pulling the handle upwards. Unscrew the tank cap and fill the tank. The tank holds 2.35 liters (80 ounces).
• The steamer must be used with TAP WATER. If the water in your area is hard, Rowenta recommends that you mix half tap water and half distilled water, which reduces the hardness. You can also use bottled spring water.
• After closing the cap, turn the tank down and hold it by the handle. Check out that no water is leaking through the cap.
• Place the water tank on the base (fig.14). If you have any difficulty to placing it, check that the water tank is not the wrong way round.

USE

Warning
Never steam a garment while it is being worn. The hose and steam head may become hot during use. This is perfectly normal. Be careful and avoid any prolonged contact.

• Only operate the steamer on the floor clear of any materials which may obstruct the base of the steamer (flat and horizontal surface). Do not obstruct the openings on the lower part of the appliance.
• If necessary, expand the pole to the desired height by unlocking it, pulling it gently and locking it again. (fig.15)
• Plug in the power cord, a beep sound is emitted and the power light on the front of the appliance turns on. (fig.16)
• Hold down the Set/On-Off button located on the steam head for 2 to 3 seconds to switch on the steamer.The steamer starts on the minimum steam output setting. The steam amount can be set to the desired level by successively pressing the Set/On-Off button (5 different settings to perfectly adapt the steam output to all fabric types, from delicate to thick ones). (fig.17)
• The steamer produces steam in 60 seconds, when in max position of variable steam.
• Put the garment directly on the rotating hanger or on another hanger that you can hang up to the hook. To steam pants, we advise you to use the two hangers as described in the picture. (fig.19)
• Grasp the steam head with the steam vents pointing away from you. Start steaming by brushing material lightly with the grain of the fabric in an up/down vertical motion. The fabric brush opens the weave of the fabrics for better steam penetration.
• Start at the top the garment and gradually move downward. Always steam in a vertical position. (fig.18)

Empty tank detector

This appliance is equipped with an empty tank detector. When the water tank is empty, a beep sound is emitted for a duration of 1 minute and the light indicators on the steam head will blink to alert you to fill the water tank. Turn off the appliance and fill the water tank. The appliance will automatically shut off after 1 minute if the water tank remains empty.

Caution
the empty tank detector does not work with fully distilled or demineralized water. We recommend you to use TAP WATER. If the water in your area is hard, mix half tap water and half distilled water.

Auto-Off function

• This garment steamer is equipped with the Auto-Off function to ensure optimum safety. Thus, if the steam head stays motionless for 5 minutes, a beep sound will be emitted for 2 minutes before the automatic shut-off.
• The garment steamer automatically turns to « Energy saving » mode before the automatic shut-off. During this time, the steam output is significantly reduced in order to limit the energy consumption before the appliance completely shuts off.
• Gently move the steam head to reactivate the appliance.

AFTER USE

• After using the steamer, switch the power off by holding down (3 sec.) the Set/Off button. Once the power indicator light turns off, you can unplug the appliance.
• Hang the steam head in an upright position on the hook when not in use.
• Turn the hanger vertically if you want to easily store the appliance away.
• Empty and rinse the water tank each time before storage in order to flush out any scale particles. (fig.20)
• Wrap the cord around the power cord clips. (fig.21)
• Do not carry the steamer by the water tank handle. This appliance includes luggage style wheels for added convenience when transporting.

Warning
Never touch the steam head until it has cooled down completely.

CLEANING

1. Clean the main unit with a damp cloth. To maintain maximum performance, your steamer must be descaled occasionally. The time between descaling operations depends on the quality of the water and the frequency with which you use the appliance. The appliance must be descaled at least once a year or after 50 hours of use.
2. To carry out a descaling operation, follow the following steps:
   • Ensure that the appliance has cooled down completely.
   • Fill the water tank with fresh water and place it on the main unit allowing water to fill the boiler.
   • Remove the tank from main unit and empty the water from the boiler through the same way the water goes inside.
   • Repeat step 2 and 3 several times until the scale has been removed.

TIPS

• We recommend checking the garment care label for manufacturer recommendations before steaming. We also recommend testing the garment on an unobtrusive area such as an inner seam.
• Read the recommendations for the maintenance of the fabrics on the labels of the clothing to be steamed.
• Test the strength of the color of the fabric on an area of the garment that is not visible (inside of a hem).
• Avoid contact between the steam head and silk or velvet.
• Certain garments are smoothed more easily on the reverse side.
• If you are using the steam head at a position close to the ground, raise the hose frequently in order to avoid the formation of condensation. You may hear a gurgling noise if the hose is obstructed in any way.
• Heavy fabrics may need to be steamed longer.
• Be careful at all times.

TROUBLESHOOTING

The Warranty

This product is guaranteed by Rowenta for 1 year against any manufacturing defect in materials or workmanship, starting from the initial date of purchase. The manufacturer’s warranty by Rowenta is an extra benefit which does not affect consumer’s Statutory Rights. The Rowenta warranty covers all costs related to restoring the proven defective product so that it conforms to its original specifications, through the repair or replacement of any defective part and the necessary labor. At Rowenta’s choice, a replacement product may be provided instead of repairing a defective product. Rowenta’s sole obligation and your exclusive resolution under this warranty are limited to such repair or replacement.

Conditions & Exclusions
The Rowenta warranty only applies within USA, Canada & Mexico, and is valid only on presentation of a proof of purchase. The product can be taken directly in person to an authorized service centre or must be adequately packaged and returned, by recorded delivery (or equivalent method of postage), to a Rowenta authorized service centre. Full address details for each country’s authorized service centre are listed on the Rowenta website (www.rowenta.com) or by calling the appropriate telephone number listed below to request the appropriate postal address.

REFERENCE LINK

https://www.rowentausa.com/instructions-for-use/csp/1830003178

DOWNLOAD PDF

Rowenta IS5100 GARMENT STEAMER User Manual