SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-featured-img

SARINA SA-KALED Karaoke Mic with LED and Speaker Guide

SARINA SA-KALED

SARINA SA-KALED Karaoke Mic with LED and Speaker Guide

SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-prudct-img

Buttons Opention

  1. MICVOL
    +:Th. microphone volume increase
    – Th. microphone volume decrease.
  2. REMIX VOL
    +:The microphone  volume increase
    _.The microphone volume decreases.
  3. M/ PDWERHold(Powe)ON/OFF PrnH(Mnds), Mnd, switching
  4. SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-fig-1
    Shore press for the next song, long for the volume increase; Uder selfie mode, press it to enable the selfie function (only for iso Systera mobile phone)
  5. SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-fig-4
    play/pause, hole it for automatic search.
  6. SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-fig-4M/V Shore press for prev song, long for the volume to decrease, Uder selfie mode, press it to enable the selfie function (only for Android system mobile phones)
  7. SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-fig-4/LED Long press: LED switch. Short press: microphone switch
  8. REC Record
  9. USB USB Slot
  10. DC5V/AUX/ANT DC5V; Power slot; AUX: Audio line-in; ANT: FM mode need to insert audio line ACTS as a radio antenna;
  11. SARINA-SA-KALED-Karaoke-Mic-with-LED-and-Speaker-Guide-fig-5
    The headset

Wireless Karaoke

  1. Supply power; Hold the M/POWER button to start the product
  2. Wireless connection: enable the wireless on the mobile phone, click to connect, successful connection if a prompt tone is produced
  3. Adjust sound adjust the sound volume of the mike and the reverberation to a suitable level
  4. Start Karaoke

Recording with mobile phone

  1. Connect the recording wire: insert the MICRO plug of the recording wire Into the MLCEI Interface of Karake Treasure and the 3.0mm Interface Into the earphone jack of the mobile phone.
  2. Open the Karaoke software on the mobile phone, such as: USING, Kugou music, or other recording APPs, select your favorite song, and record the song according to the above-mentioned singing method
  3. Test and save the song according to the instructions of the Karaoke software.

Selfie function

  1. Press the M/POWER button to switch from wireless mode to selfie mode, 2 Enable wireless in the mobile phone, search “shutter”, and click connection;
  2. Open the photograph interface of the mobile phone, and press the wor/v-button to take photos Note: 4.2.2 or higher version for Android system, 6.0 or higher version for iOS system, It doesn’t support other versions temporarily. It doesn’t support the mobile Phone which has the independent and solid photograph button.

Technical Parameters:

  • Max sound pressure Level: >115DB 1KHZ TDH <1% Reverberation
  • Mode: sound effect reverberation
  • Power Supply: Built-in 18850Li-battery
  • Battery Capacity: 1200mAh FM Radio: 87.5~108Hz

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help. RF warning statement:

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

REFERENCE LINK

https://sarinasales.com/

Leave a Reply