Table of contents
show
AULA SC100 Wireless Rechargeable Mouse User Manual
Specification
- Working Voltage: 3.2 ~ 4.2V
- Li Battery: 800mAh
- DPI: 3 Gear 800-1200-1600 (Default:1600)
- Return Rate: 250 (Default) -125
- Size: 140 (L) x78 (W) x37 (H) ± 0.5mm
- Buttons: 6
- Pair Method: Free Code
- Material: ABS
Combination Keys To Switch DPI
- Press the DPI Switch to exchange between 800,1200 to 1600
- Long Press (Right Button + Middle Button) For 3 seconds Switch Return Rate 250-125 (Default as 250).
Description of Working Mode
- Working Mode: When the mouse is moving or the keys are pressed, the mouse is in working mode.
- Level 1 Sleep Mode: If the mouse stops moving for 1 second, it enters level 2 sleep mode.
- Level 2 Sleep Mode: If the mouse stops moving for 1 second, it enters level 2 sleep mode and the mouse sensor light twinkles.
- Deep Sleep Mode: (need to press the button or wheel to wake up)
- When the mouse does not move or has no key operation, after 15 minutes it enters deep sleep mode.
- When you close the computer or unplug the receiver, the mouse cannot detect the receiver after 5 seconds and it enters deep sleep mode.
Mouse Power Consumption
(Test Surface: A4 white paper: 3065 photoelectric IC)
| Working Voltage | Working current | Level 1 sleep | Level 2 sleep | Deep Sleep | |
| 3.7V | A4 Paper | 7.35mA~8.65mA | 0.23mA | 0.15mA | 15uA |
| Black-Faced | 8.87mA~9.32mA | 0.23mA | 0.15mA | 15uA | |
Use Guide
- Remove the USB receiver at the bottom of the mouse.
- Insert the USB receiver into a USB port on your computer.
- On the bottom of the mouse, switch the button to ON. The mouse LED is lit, the computer detects the mouse, and the mouse is ready to use.
- When not in use, turn the mouse OFF. Store the USB receiver at the mouse’s bottom.
Troubleshooting
The mouse does not operate or is not recognized.
- Make sure the power switch is in the ON position.
- Try to plug the receiver into a different USB port.
- If the mouse LED still does not light, turn the mouse off, and then on.
The cursor moves erratically or misses button clicks.
- Remove metal objects between the mouse and the receiver.
- Place the receiver away from other electrical devices.
- Try moving the receiver closer to the mouse.
- Check battery power by turning the mouse off, and then on. If the mouse LED does not light, pls use a USB cable to charge the mouse first.
The mouse LED is lit.
- If the LED is lit constantly for 10 seconds, the batteries have sufficient power.
- If the LED is flashing once every second, the batteries are low.
- If the LED is flashing four times every second, the batteries are severely low. The mouse cursor at this moment can not be moved.
Cleaning Your Mouse
Use disinfectant wipes. Do not use any cleaners that may damage the surface of the mouse.
