Table of contents
show
Swann SWHOM-DC810B Wireless Door Chime User Guide
Batteries
Doorbell receiver
- The doorbell receiver unit requires 3 x AAA batteries to operate (which are not included). For best performance, use fresh, high quality AAA alkaline batteries.
- To install them, unclip the battery cover on the rear of the unit to reveal the battery compartment.
- The polarity of batteries is indicated by the markings inside the battery compartment.
Doorbell unit
- The doorbell requires 1 x 23A/12V battery (included).
- To install the battery, pry off the back cover using a small, flat-head screwdriver in the small notch at the bottom of the doorbell.
- To finish, clip the back cover back onto the doorbell unit making sure the rubber seal is fi tted properly to ensure the unit remains water resistant.
Setting the volume and chime
- To change volume, press the volume button on the side of the receiver unit. Each time you press it, the volume level moves to the next lowest volume. There are four volume levels. When you reach the lowest volume, the next press moves back to the highest volume again.
- To change chimes, press the chime select button on the side of the unit. The unit will play the next chime. Keep pressing the button until you hear a chime you like. You do not need to confirm your selection.
Operating Guide
Mounting the doorbell
- Peel off one side of the adhesive strip and attach it to the rear of the backing plate, ensuring none of it is visible from the front.
- Find the area you want to mount the doorbell. Flat, smooth surfaces are ideal. Make sure they are clean and dry before mounting.
- Peel off the other side of the adhesive strip and attach the doorbell to the mounting surface
Mounting the receiver (speaker unit)
There is no requirement to mount the receiver. You may find it more convenient to place it on a shelf or table. One of the benefits of a battery operated wireless doorbell is that if you have a large house, you can take the receiver with you. No more missing visitors because you were all the way at the back of the house or by the pool! If you would like to mount the device, you simply need to attach the two screws to a wall.
