Technics EAH-A800 Wireless Noise Cancelling Over Headphones User Manual

Technics EAH-A800 Wireless Noise Cancelling Over Headphones User Manual

About Bluetooth

Restrictions of use

• Wireless transmission and/or usage with all Bluetooth® equipped devices is not guaranteed.
• Depending on the specifications and settings of a device, it can fail to connect or some operations can be different

IMPORTANT SAFETY INSTRUCTIONS

Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference.

• Do not use this apparatus near water.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
• Clean only with dry cloth.

Accessories

Please check and identify the supplied accessories. To order accessories, contact the dealer from whom you have made your purchase.

• 1 x Carrying case
• 1 x USB charging cord
• 1 x Detachable cord
• 1 x Airplane adaptor

Only for U.S.A.:
To order accessories, refer to “Limited Warranty”

Maintenance

• Clean this unit with a dry and soft cloth.
• Do not use solvents including benzine, thinner, alcohol, kitchen detergent, a chemical wiper, etc. This might cause the exterior case to be deformed or the coating to come off.

Safety precautions

THE FOLLOWING APPLIES ONLY IN THE U.S.A. AND CANADA. This device complies with Part 15 of FCC Rules and Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

• this device may not cause interference, and
• this device must accept any interference, including interference that may cause undesired operation.

FCC ID: ACJ-EAH-A800
Model: EAH-A800
IC: 216A-EAHA800
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

(For the U.S.A. only)

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.

(For Canada only)

EAH-A800 has been tested and found to comply with ISED radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules.

THE FOLLOWING APPLIES ONLY IN THE U.S.A. FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Any unauthorized changes or modifications to this equipment would void the user’s authority to operate this device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.

Unit

WARNING:

To reduce the risk of fire, electric shock or product damage,

• Do not expose this unit to rain, moisture, dripping or splashing.
• Do not expose units containing batteries to excessive heat (e.g., from storage in direct sunlight, fire or the like).
• Use only manufacturer’s recommended accessories.
• Do not disassemble the product.
• Do not repair this unit by yourself. Refer servicing to qualified service personnel. Avoid the use in the following conditions
• High or low extreme temperatures during use, storage or transportation.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
• Extremely high temperature and/or extremely low air pressure that can result in an explosion or the leakage of flammable liquid or gas.

• Do not place this unit near a heat source.
• Do not listen with this unit at high volume in places where you need to hear sounds from the surrounding environment for safety, such as at railroad crossings, and construction sites.
• Keep this unit away from something susceptible to the magnetism. Such devices as a clock may not operate correctly.
• When using this unit in an airplane, heed the instructions given by the airline company. Some airlines may forbid your using the unit. For further details, contact the airline you will be flying with.
• Do not wear the headphones while charging.
• Contains small parts which may be a choking hazard. Not suitable for children under age 3.
• This product contains magnetic material. Consult your physician on whether this might affect your implantable medical device.
• Keep the airplane adaptor out of reach of children to prevent swallowing.
• Proper charging is not possible if there is dust or droplets of water on the charging terminal of the headphones. Remove the dust or water droplets before charging.
• Be aware that this unit may get warm while charging or immediately after charging. Depending on your constitution and health status, putting the headphones on may trigger adverse reactions such as skin redness, itching, and rash if the headphones have just been disconnected from the power source and are still warm.
• Do not use any other USB charging cords except the supplied one.
• Do not use any other detachable cords except the supplied one.

• Battery
• Do not heat or expose to flame.
• Do not leave the battery in a car exposed to direct sunlight for a long period of time with doors and windows closed.
• Battery mishandling can cause electrolyte leakage which can damage items the leaked fluid comes into contact with. If electrolyte leaks from the battery, consult your dealer. Wash thoroughly with water if electrolyte comes in contact with any part of your body.
• When disposing of the battery, please contact your local authorities or dealer and ask for the correct method of disposal.
• Allergies
• Discontinue use if you experience discomfort with the ear pads or any other parts that directly contact your skin.
• Continued use may cause rashes or other allergic reactions.
• Precautions for listening with the Headphones
• Excessive sound pressure from earphones and headphones can cause hearing loss.
• Do not use your headphones at a high volume. Hearing experts advise against continuous extended play.
• If you experience a ringing in your ears, reduce volume or discontinue use.
• Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.
• You should use extreme caution or temporarily discontinue use in potentially hazardous situations.
• Do not use the headphones if they emit any loud unusual noise. If this happens, turn the headphones off and contact customer service.
• Remove headphones immediately if you experience a warming sensation or loss of audio.
• The headphones do not play audio while charging.

This unit may receive radio interference caused by mobile telephones during use. If such interference occurs, please increase separation between this unit and the mobile telephone. Use only the supplied USB charging cord when connecting to a computer.

• Remove the left ear pad to view certification information.
• Certification information (a) is indicated on the speaker plate portion, which becomes visible when the left ear pad (L side) is removed.
• To attach the ear pad, insert the clips b into the matching parts c on the ear pad. (There are 6 clips) If you pull the ear pad too much, the ear pad can tear.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Panasonic Corporation is under license. Other trademarks and trade names are those of their respective owners. LDAC and LDAC logo are trademarks of Sony Corporation. QR Code is a registered trademark of DENSO WAVE INCORPORATED. Other system names and product names appearing in this document are in general the registered trademarks or trademarks of the respective developer companies. Note that the TM mark and ® mark do not appear in this document.

This product incorporates the open source software other than the software licensed under the GPL V2.0 and/or LGPL V2.1. The software categorized as above are distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY, without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. Please refer to the detailed terms and conditions thereof shown at the following web page. https://panasonic.jp/support/global/cs/audio/download/index.html

This unit complies with the “High Resolution Audio” standard of the Japan Audio Association.

• To enjoy wireless high-resolution quality (sound quality certified by the high-resolution wireless logo), use a playback device with the high-resolution wireless logo and set the Bluetooth® sound quality setting to sound quality priority mode / LDAC 990 kbps.
• In modes other than the above (connection priority mode, etc.), playback may not be possible with high resolution quality.

Specifications

To remove the battery when disposing of this unit

The following instructions are not intended for repairing purposes but for the disposal of this unit. This unit is not restorable once disassembled.

• When disposing of this unit, take out the battery installed in this unit and recycle it.

1. Remove the left ear pad.
2. Remove the sealing sponges and remove the 5 screws.
3. Remove the part a in step 2.
4. Disconnect the connector (b), and peel off the tape fixing the battery in place, remove the battery (c).

Contact to Authorized Representative: Panasonic Marketing Europe GmbH, Panasonic Testing Centre, Winsbergring 15, 22525 Hamburg, Germany

Declaration of Conformity for Radio Equipment in UK

Panasonic Corporation declares that the radio equipment type (Model Numbers are referred in the Operating Instructions) is in compliance with The Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: https://www.ptc.panasonic.eu/compliance-documents Contact in the UK : Panasonic Testing Centre on behalf of Panasonic UK, a branch of Panasonic Marketing Europe GmbH (Importer), Maxis 2, Western Road, Bracknell, Berkshire, RG12 1RT

REFRENCE LINK