TRIBIT IC-BTS25 Wireless Speaker featured

TRIBIT IC-BTS25 Wireless Speaker User Manual


TRIBIT IC-BTS25 Wireless Speaker User Manual

TRIBIT IC-BTS25 Wireless Speaker

Safety Precautions

  • Avoid dropping the speaker on the floor.
  • Do not try to disassemble or repair the speaker unless you are a technician.
  • Do not submerge the speaker in water.
  • Never expose the speaker to extreme high or low temperatures.
  • Stop use immediately if thunderstorm happens.
  • Do not clean its surface with any corrosive cleanser or other chemical solutions.


  • Bluetooth version: V4.2
  • Bluetooth profile: A2DP, AVRCP, HFP, HSP
  • Driver: 2 x <l>45mm Passive radiator
  • Output power: 2 x 12W
  • Signal-to-noise ratio • 80d8
  • Frequency response: 80-20KHz
  • Battery: 7.4V / 2200mAh
  • Music play time: Up to 20 hours I varies by volume level and music files)
  • Charging time: 4 hours@SV/1.SA
  • Dimensions: 65xl98x68 mm/ 2.56×7.79×2.68 in
  • Weight: 595g / 20.98oz

What’s in the Box

TRIBIT IC-BTS25 Wireless Speaker fig 1

Overview Buttons & Indicators

TRIBIT IC-BTS25 Wireless Speaker fig 2

TRIBIT IC-BTS25 Wireless Speaker fig 3


TRIBIT IC-BTS25 Wireless Speaker fig 4

Bluetooth Pairing

TRIBIT IC-BTS25 Wireless Speaker fig 5



Power ON/OFF


Power Button

Press the button to turn on / off the speaker

Pair a Bluetooth Device



Press the button to manually enter pairing mode

Volume Up



Press the button to increase the volume level

Volume Down



Press the button to decrease the volume level


Press once the



Next track



Double press the button

Previous track



Press the button for3times
Answer/end the incoming callMFBPress once the button
Reject an incoming callMFBPress and hold the button for 2s


Voice dial function




Press and hold the button for 2s to activate ( your device

must support this function)


If this speaker has any problem, you can try to press and hold Volume + and Volume – buttons simultaneously for Ss to reset this speaker and remove the old pairing in your Bluetooth device, and then pair again.

Customer Service

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment hos been tested and found to comply with the limits for a Closes B digital device, pursuant to Port 15 of the FCC Rules. These limits ore designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which con be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into on outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio / TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.




Leave a Reply