Samsung VCA-SAE90 Vacuum Cleaner Manual
Product specifications
NOTE
The wave pattern on the exterior of the product is a natural appearance due to the use of pearl plastic materials and its pearl distribution.
Accessories
NOTE
If you want to purchase an additional dust bag, check the model name (VCA-ADB90) and Samsung logo (SAMSUNG ) first and contact a Samsung Electronics retailer nearest you.
Safety Information
The following contents are written for users’ safety and the prevention of property damage. Before using the product, please read this manual thoroughly and use the product correctly. For safety reasons, people with physical, sensory difficulties, or mental disorders, lack of experience, and knowledge should not use this product without the supervision of their guardians.
Other symbols used
NOTE
Indicates that the following text contains additional important information.
- For information on Samsung’s environmental commitments and product-specific regulatory obligations e.g. REACH (WEEE, Batteries) visit: Samsung. com/UK/about Samsung/Samsung electronics/corporate citizenship/data_corner. html
Failure to meet these requirements could cause damage to the internal parts of the vacuum and void your warranty. If your appliance is fitted with a non rewireable BS 1363 plug it must not be used unless an appropriately rated (ASTA approved to BS 1362) fuse is fitted in the carrier contained in the plug. To determine the correct rating of the fuse refer to the marking on the plug.
General
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children should not play with the appliance. Children should not clean or perform maintenance on the product without adult supervision.
Installation
CAUTION
- The clean station should be placed and used on a stable floor.
- If the product falls over, an injury or product and floor damage may occur.
- Do not place or use the product on an uneven floor, a carpet, a living room table, a desk, etc.
- If the product falls over, an injury or product and floor damage may occur.
- Do not place the product at a wall behind which pipes (gas or water etc.) or electrical cables are installed.
- Do not install the product near water, in an area with excessive moisture, or near windows, etc.
- Do not install the product in a place where people frequently pass by, near an entrance, or a narrow passage.
- If people trip over the product, an injury or product damage may occur.
Power related
WARNING
- Do not bend the power cord with excessive force or put heavy objects on the power cord.
- Otherwise, electric shock or fire may occur.
- If there is dust, water, etc. on the contact point of the power plug pins, wipe them carefully.
- Otherwise, abnormal operation or electric shock may occur.
- Do not pull the power cord and do not touch the power plug with wet hands.
- Otherwise, electric shock or fire may occur.
- Do not use a power source with the incorrect voltage. Do not use a multi-plug outlet or power strip for the product. Do not leave the power cord lying on the floor. Attach the cord close to a wall.
- Except for an authorized repairman, do not disassemble or modify the clean station.
- When using the product on a veranda, make sure the power cord and the power plug do not touch the water.
Operation
WARNING
- Static electricity may occur depending on the humidity, temperature, floor material, etc. of your operating environment. If it happens repeatedly, contact a Samsung service center.
- Do not cause a short circuit by touching the power terminal with chopsticks, metal screwdrivers, etc.
- Otherwise, product malfunction or electric shock may occur.
- Make sure that any liquid such as water or juice does not touch the inside or outside of the product.
- Otherwise, electric shock or fire may occur.
- The clean station is manufactured for Samsung Jet wireless vacuum cleaners only, so do not use the clean station for other purposes.
- Do not use the product near heating appliances such as heaters, or in areas containing combustible sprays, or flammable materials.
- Otherwise, fire or product deformation may occur.
- If there is a gas leak, or a combustible spray is used such as a dust remover, do not touch the power outlet and open the window for ventilation.
- Otherwise, an explosion or fire may occur.
- If the product makes a strange sound or emits a smell or smoke, turn off the product immediately, and then contact a Samsung service center.
- Otherwise, electric shock or fire may occur.
Maintenance
WARNING
- When cleaning the exterior of the product, unplug the product first and then wipe it with a dry towel. Do not spray water directly onto the product or wipe it with volatile materials such as benzene, thinner, or alcohol.
- Otherwise, product damage such as plastic breakage, deformation, discoloration, printing deterioration, etc. may occur.
CAUTION
- Do not push the clean station in case it falls over.
- Personal injury, floor, and product damage may occur.
- When the clean station emits a bad odor, replace the dust bag or clean the filters.
- When you pull the power cord out of the groove at the bottom of the clean station, do not pull it hard. Turn the cord gently on its side so that it can come out without interruption.
- Otherwise, the power cord may get damaged and could cause an electric shock or fire.
Installing the clean station
Installation guide
As the outlet is at the rear of the product, do not put the product close to a wall, allow 10 cm space between the wall and the product, and place the product on a stable floor.
Put the power cord into the groove at the bottom of the clean station, arrange the cord neatly along the wall, and plug the product in.
- When the cord is placed on the floor carelessly, the power cord may be damaged or a person can trip over the cord.
- When the clean station is plugged in, the product status indicator turns ‘blue’ and then goes off.
Using the clean station
The clean station is compatible with the provided dustbin only.
Press the [PUSH] button on the upper cover of the clean station.
Insert the dustbin into the clean station. Dust is ejected automatically.
- When the clean station is in operation, the product status indicator turns ‘blue’.
- Press the [Start/Stop] button to stop operation.
When the clean station’s operation stops completely, pull the dustbin out and close the clean station by pressing the upper cover firmly.
NOTE
- When dust still remains inside the dustbin even after using the clean station, press the [Start/Stop] button to operate the clean station.
- Press the button again to stop the operation.
- If the dustbin is filled with dust and will not eject it properly, use a hand to push down the top of the washable micro filter, and then operate the clean station.
- When there are foreign object residues, remove them by referring to the ‘Maintaining the clean station’ section of the manual.
CAUTION
- After using the clean station, you should close the dustbin by pressing the bottom cover firmly until you hear it ‘click’.
Dust bag
Time to replace a dust bag
When the product status indicator turns ‘red’, you should replace the dust bag.
- Grip both sides of the front cover and pull the cover towards you.
- Open the cover by pulling the [PULL] button.
Press the ‘PUSH’ lever.
Pull the ‘PULL’ lever out in a diagonal direction and remove the dust bag.
Insert a new dust bag towards the back and push the ‘PULL’ lever upward firmly until you hear it ‘click’.
- Be cautious not to assemble incorrectly when inserting the dust bag.
After replacing the dust bag, assemble the clean station in reverse order.
NOTE
- If the dust bag emits a bad odor even though it is not filled with dust, replace the dust bag.
- When you operate the clean station after replacing the dust bag, the status indicator changes from red to blue.
Dustbin
After emptying the dustbin, clean it with water and dry it completely before use.
Premotor Filter
- Lift up the Premotor Filter inside the product and pull it out. Then, detach the nonwoven fabric from the filter.
- Remove the dust on the nonwoven fabric by shaking it and reassembling the Premotor Filter.
Ultra fine Dust Filter
- Do not clean the Ultrafine Dust Filter with water. Shake the filter.
- To maintain the best performance of the Ultrafine Dust Filter, replace the filter once a year.
REFERENCE LINK
DOWNLOAD LINK
Samsung VCA-SAE90 Vacuum Cleaner Manual
