WaterPik WP-60/65/70/72 Water Flosser User Manual
Prepare the Reservoir:
Remove the reservoir from the base and fill it with lukewarm water.
Replace the reservoir
onto the base, PRESSING DOWN FIRMLY.
Select and Insert Tip:
Press the tip firmly into the handle. When the tip is properly inserted there should be no gap between the control knob and the tip.
Prime Unit (First Time Use Only):
Prior to the Very First Use of the Unit: Set the pressure control slide switch on the handle to high, and point the tip into the sink. Turn the unit ON until water flows from the tip, turn the unit OFF.
Adjust Pressure and Pause Control:
For first-time users, adjust the pressure control to the lowest position. Gradually increase pressure as you prefer. You can temporarily stop the water flow by pressing the pause button on the handle.
This device is only compatible with a voltage system of 120VAC, 60Hz. Do not plug this device into a voltage system that is different. Cet appareil est uniquement compatible avec un système de tension de 120 VCA, 60 Hz. Ne pas le brancher dans un système de tension différent.
On/Off Procedure:
Always place tip in mouth before turning unit on. Toujours placer l’embout dans la bouche avant de mettre l’appareil en marche.
Lean over the sink and close your lips enough to prevent splashing, while still allowing water to flow from your mouth into the sink. Turn the unit ON. Always PAUSE or turn the unit OFF before removing the tip from the mouth.
Technique Tips for Best Results:
Aim the tip just above the gumline at a 90-degree angle. Starting with the back teeth, follow the gumline and pause briefly between teeth. Continue until all areas around and between teeth have been cleaned.
Tip Removal:
To remove the tip, simultaneously hold the control knob down and lift the tip up.
REFERENCE LINK
https://store.waterpik.com/wp-6070-replacement-hose-and-handle
