Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Feature-Image

Waterpik WP-950 Plus Sonic Toothbrush Water Flosser User Manual

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-1

Waterpik WP-950 Plus Sonic Toothbrush Water Flosser User Manual

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-2

IMPORTANT SAFEGUARDS

  • When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following:
    READ ALL INSTRUCTIONS BEFORE USING DANGER:
    To reduce the risk of electrocution:
  • Do not handle plug with wet hands.
  • Do not place in or drop into water or other liquid.
  •  Do not use while bathing.
  • Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-3 Do not place or store product where it can fall or be pulled into a tub or sink.
  •  Do not reach for a product that has fallen into water. Unplug immediately.
  •  Check the power supply cord for damage before the first use and during the life of the product.
    WARNING: To reduce the risk of burns, electrocution, fire, or injury to persons:
  •  Do not plug this device into a voltage system that is different from the voltage system specified on the device or charger.
  • If product is opened/disassembled for ANY reason warranty is VOID.

PRODUCT DESCRIPTION

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-4

GETTING STARTED WITH YOUR WATER FLOSSER

NOTE: All tips and brush heads not included in all models.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-5

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-6

Powering the Unit

Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be sure it is turned on.

Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace the reservoir over the base and press down firmly and close the lid.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-7


Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-8

Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until tip clicks into place. The colored
ring will be flush with the top of the handle if the tip is correctly locked into place. To remove tip from the handle push the tip eject button on the handle.
CAUTION: Do not press tip eject button while unit is running.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-9


Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-10

Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point the handle and tip into sink. Turn unit ON (l) until water flows from the tip. Turn unit OFF (O).

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-11
Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-12

Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting (pressure setting No. 1) for first-time use.Gradually increase pressure over time to the setting you prefer – or as instructed by your dental professional.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-13

Recommended Technique
For best results, start with the back teeth and work toward the front teeth. Glide tip along gum line and pause briefly between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth. Lean over sink. Direct the stream at a 90-degree angle to your gum line with tip in mouth.
Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-14

CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER

Orthodontic Tip
To use the orthodontic tip, gently glide tip along gum line, pausing briefly to lightly brush area between teeth and all around orthodontic bracket, before proceeding to the next tooth.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-2

Plaque Seeker Tip
To use the Plaque Seeker tip, place the tip close to the teeth so that the bristles are gently touching the teeth. Gently glide tip along gum line, pausing briefly between teeth to gently brush and allow the water to flow between
the teeth.
Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-3

Using Mouth wash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and antibacterial solutions. After using any special solution, rinse unit to prevent clogging by partially filling reservoir with warm water and running unit with tip
pointed into sink until unit is empty.

Waterpik-WP-950-Plus-Sonic-Toothbrush-Water-Flosser-User-Manual-Image-4

GETTING STARTED WITH YOUR SENSONIC PROFESSIONAL PLUS TOOTHBRUSH

Excess Power Cord Storage
After determining the length of power cord necessary, push extra cord into the cavity on the bottom of the unit and insert cord into the retention slots.

CARE OF YOUR SENSONIC PROFESSIONAL PLUS TOOTHBRUSH

Sonic brushing

  •  Slide the brush head onto handle and push it down firmly.
  •  Place the brush head into your mouth before turning the unit on.
  • Press button once for low speed, and twice for high speed.
  •  If you hold the on/off button down briefly while in the low speed position the brush will shut off.

DOWNLOAD PDF

Waterpik WP-950 Plus Sonic Toothbrush Water Flosser User Manual_compressed

REFERENCE LINK

visit waterpik.com/

Leave a Reply