Table of contents
show
Kasa Smart Smart Wi-Fi Dimmer Switch User Manual
Product Introduction
Built-in motion and ambient light sensors work together to realize hands-free control. Kasa smart dimmer switch turns on and dims the lights automatically, saving you effort and electricity bills.
Wire Your Switch
- Turn off the circuit breaker. Then remove the old wallplate of the wall switch and label the Ground and Neutral wires.
Ground: Usually green or copper. Neutral: Usually white and not connected to a dumb switch. Line: Usually black and coming from the circuit breaker. Load: Usually black. One end is connected to the light. If you are unsure, consult a qualified electrician - Disconnect the wires from the old switch.
- Identify Line and Load wires.
- Turn on the circuit breaker. Use a voltage detector to identify the energized wire (Line wire)
- Turn off the circuit breaker. Label the Line and Load wires.
- Turn on the circuit breaker. Use a voltage detector to identify the energized wire (Line wire)
- Connect the wires to the smart dimmer switch as shown below.
- Line up the switch with the mounting holes. Secure it with screws.
- Attach the wallplate. Then the wiring is finished.
Set Up Your Camera
Follow the steps below to get started with your new camera.
Step 1. Download Kasa
Get the Kasa Smart app from the App Store or Google Play, or by scanning the QR code below.
Appearance
Button Explanations
 | Decrease or increase the brightness. |
| Reset | Press and hold for about 5s to reset Wi-Fi while keeping other settings. Press and hold for about 10s to restore your switch to factory default settings. |
| Restart | Press to restart your switch. |
LED Status
| Flashing amber & green | Ready for setup. |
| Flashing green | Connecting to Wi-Fi. |
| Stay green for 30s | Connected to Wi-Fi. |
| Solid red | Disconnected from Wi-Fi. |
| Flashing amber | Device resetting. |
| White | Light fixture is off. |
Specifications
- Rating: 120V~ 60Hz
- Load: 300W Incandescent, 150W LED
- Operation temperature: 0~40℃
- Method of mounting included: Independently mounted
- (Vertically position only);
- Operating control, Type 1 action Pollution Degree 2, Rated Impulse Voltage 2500 V
- Software Class A, NEMA Type 1
Safety Notice
Before installing, servicing, or removing the switch, read and follow all safety precautions including the following:
- CAUTION – Risk of Electric Shock – More than one disconnect switch may be required to de-energize the equipment before servicing. A circuit breaker which disconnects the Line and Neutral conductor simultaneously is suitable. Ensure power is off at the circuit breaker before removing or installing any switch. Use a non-contact voltage tester to ensure the power is off.
- The Smart Switch must be installed and used in accordance with the National Electric Code (NEC) or your local electrical code. If you are unfamiliar with these codes and requirements or are uncomfortable performing the installation, consult a qualified electrician.
- Do not install the Smart Switch with wet hands or when standing on wet or damp surfaces.
- Install only in a suitable UL Listed outlet box (suitable dimensions: H > 2.95 in./75 mm, W > 1.81 in./46 mm, D > 2 in./51 mm).
- Tighten terminal screws to 13 lbs-in.
REFERENCE LINK
https://www.kasasmart.com/us/products/smart-switches/kasa-smart-wi-fi-light-switch-dimmer-hs220
