Anker Wireless Vertical Ergonomic Mouse Welcome Guide

Anker logo

Anker Wireless Vertical Ergonomic Mouse Welcome Guide


At a Glance


  • Scroll Wheel
  • Left Button
  • Right Button
  • DPI Switch
  • Next Page Button (Not for Apple Mac OS)
  • Previous Page Button (Not for Apple Mac OS)
  • Nano Receiver


  • DPI Switch: Press this button to switch between 800, 1200, and 1600 DPI.
  • Next Page Button: Press this button to go forward one page while web browsing.
  • Previous Page Button: Press this button to go back one page while web browsing.


  • Remove the battery cover.
  • Insert 2 AAA batteries (not included) into the battery slot.
  • Remove the nano receiver and insert it into the computer’s USB port. The driver will automatically install.
  • Press the DPI switch to shift to the desired DPI level.





For FAQs and more information, please visit:



@Anker @Anker Japan @Anker Deutschland
Anker-Wireless-Vertical-Ergonomic-Mouse-Fig7 @AnkerOfficial @Anker_IP
Anker-Wireless-Vertical-Ergonomic-Mouse-Fig8 @Anker



Anker-Wireless-Vertical-Ergonomic-Mouse-Fig10Don’t expose to liquids

Anker-Wireless-Vertical-Ergonomic-Mouse-Fig11Don’t disassemble

Anker-Wireless-Vertical-Ergonomic-Mouse-Fig12Avoid dropping

Anker-Wireless-Vertical-Ergonomic-Mouse-Fig13Avoid extreme temperatures


  • Make sure the nano receiver is plugged into your device’s USB port. If it is still unresponsive, plug the receiver into another USB port on your device.
  • Your mouse is not paired with the nano receiver. To pair: Turn on the mouse, plug the nano receiver into your device’s USB port, and then hold the scroll wheel and the right button of the mouse simultaneously. Release the two buttons after 3 seconds to finish paring. If unsuccessful, unplug the receiver, turn off the mouse, and then repeat the above steps to restart pairing. During pairing, make sure the mouse is close to the receiver.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference.
  • This device must accept any interference received, including interference that may cause undesired operation.
  • Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Anker-Wireless-Vertical-Ergonomic-Mouse-Fig14This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.

Customer Service



A7852_Anker 2.4G Wireless Vertical Ergonomic Optical Mouse User Manual

Leave a Reply