Table of contents
show
Bambu Lab Automactic Material System User Manual
Get Started
Warnings
- When operating the AMS, we recommend using Bambu Filament, which has been thoroughly tested to work with the AMS.
- Please make sure to avoid using soft materials like TPU or damp PVA, as they can get stuck in the AMS.
- AMS supports spool width of 50 mm – 68 mm. We highly recommend using filament with plastic spools that fit correctly inside the AMS. If you prefer to use cardboard spools, we strongly advise using a spool adapter to reduce the risk of slippage and debris getting left behind in the AMS.
- If you run into any issues with specific filaments, please let us know so that we can provide better advice to our community
Component Introduction
Accessory Specification
AMS Assembly
Filament Pre-Loading
Place at least one spool of Bambu Filament into the AMS. Turn on the power to start the printer and the AMS. Insert the filament into the filament inlet. The filament will be automatically pre-loaded when detected.
REFRENCE LINK
